4.9.2.2 Only For "It" Version; Tyre Inflating (With Tubeless Inflating Device For "I"-"It" Models Or Tyre Inflating Gun) - Ravaglioli G7645 Série Manuel D'instructions

4.9.2.2 Only for "IT" version

1) Secure the wheel from the inside onto the jaws 1 (Fig.
O) of the chucking table 2 by means of pedal.
2) Push the protection tab down on inflating head 4
Fig.O (at inflating hose edge) and insert it on the tyre
valve. Release the protection tab and make sure that
the fitting is tightened on the valve.
3) Press the nozzle 6 on the rim (see Fig.Q).
4) Raise the back bead while the pedal 3 (Fig.R) is
pressed in second position to trigger air jets: both tyre
beads separate and tighten.
5) Take hands off the tyre and keep operating pedal 3
in first position: while beads are tightened, air begins
to inflate the tyre until both beads pass over rim
edges (tyre beading).
6) Release the wheel from jaws 1 of chucking table 2.
7) Complete tyre inflating by pushing pedal 3 in first
position. Check pressure regularly and make sure
pressure do not exceed the max value indicated by
vehicle manufacturer (if so, deflate the tyre by
operating the button located near manometer 5 (Fig.O).
4.9.3 Tyre inflating (with tubeless inflating
device for "I"-"IT" models or tyre inflating
gun)
1) Release the wheel from jaws 1 of chucking table 2
(Fig.R) by operating pedal.
2) Press the tab on the inflating head 4 (at the end of the
inflating hose) and insert it on the tyre valve, release
the tab and make sure that inflating head is tightened
on the valve.
3) Take hands off the tyre and inflate it (press tubeless
inflating device pedal 3 (Fig.P) in first position for "I"
models or push the proper button on the inflating
gun). Check pressure regularly and make sure
pressure do not exceed the max value indicated by
vehicle manufacturer (if so, deflate the tyre by
operating the button located near manometer 5 (Fig.O).
Fig.Q
Fig.R
7300-M009-0_R
6
4
4
2
3
GB
1
45