4.9.2.1 Only For "I" Version - Ravaglioli G7645 Série Manuel D'instructions

4.9.2.1 Only for "I" version

1) Make sure all air lances of jaws 1 (Fig. O) are clean.
2) Secure the wheel from the inside onto the jaws of the
chucking table 2 by means of pedal (in this position
air lances on the jaws can orientate air jet on tyre
lower bead in order to ensure bead tightness on rim
edge).
3) Push the protection tab down on inflating head 4
Fig.O (at inflating hose edge) and insert it on the tyre
valve. Release the protection tab and make sure that
the fitting is tightened on the valve.
4) Hold the tyre so that the upper bead comes into
contact with the rim and the lower bead moves sligltly
away from the rim, thus creating a narrow opening
allowing air passage (see Fig. R).
5) Push down inflating pedal 3 (Fig.P and Fig.R) in
second position to trigger air jets: both tyre beads
separate and tighten.
6) Take hands off the tyre and keep operating pedal 3
in first position: while beads are tightened, air begins
to inflate the tyre until both beads pass over rim
edges (tyre beading).
7) Release the wheel from jaws 1 of chucking table 2.
8) Complete tyre inflating by pushing pedal 3 in first
position. Check pressure regularly and make sure
pressure do not exceed the max value indicated by
vehicle manufacturer (if so, deflate the tyre by
operating the button located near manometer 5
(Fig.O).
44
1
2
Fig.O
Fig.P
7300-M009-0_R
5
4
3