Activating Total Supervision - INTERVOX RESIDENCIA 3 Guide Utilisateur

4. Activating Total Supervision

● On the alarm unit
Before activating supervision, check that the doors and windows are correctly closed.
Two procedures can be used to activate total supervision:
Procedure with entry of an access code:
Total supervision on (key 2).
If the alarm unit detects an error, an alert signal is generated and the reason for the
alert is displayed on the alarm unit.
If it is not possible to correct the error, you have 10 seconds to force operation by
pressing the Total supervision on key again. The error is ignored and supervision is
activated but the event is stored in the event log.
Procedure without code:
2 seconds.
If the alarm unit detects an error, it ignores the error. Total supervision is activated but
the event is stored in the event log.
The time delay on exit is activated and the alarm unit generates two beeps. During the time
delay on exit, the alarm unit generates a continuous audio signal and LED 1 flashes. You
must exit from the premises before the end of the time delay.
The alarm unit activates total supervision at the end of the time delay.
● From a keypad or remote control unit
Total supervision can be activated directly from a remote control unit or a remote keypad
using the same procedure. If the option is programmed on the keypad, you can activate
supervision by holding the Total supervision on key depressed for 2 seconds without
having to enter a code.
If the option is programmed, the siren outputs two beeps for confirmation (see the Settings
menu).
If the alarm unit detects an error, supervision is inhibited and the alarm unit generates four
beeps.
You cannot force the activation of supervision from the keypad or the remote
control unit. Check the error displayed on the alarm unit.
Enter your access code then press
code
+
Hold Total supervision on (key 2) depressed for
- 17 -