Audio And Visual Signals - INTERVOX RESIDENCIA 3 Guide Utilisateur

3 Audio and Visual Signals

Indicators on Display
Lit: Line power on
Unlit: Line power failure
Lit: The alarm unit informs
you that an alarm is stored
and prompts you to view the
log
Audio Signals Generated by the Alarm Unit:
♫
Alert
Alert signal generated when the alarm unit is turned on indicating that a detector is in
alarm status or faulty or that the battery is low or inoperative.
Time delay on
♫
exit
Signal generated during the time delay on exit.
Time delay on ♫
entry
Signal generated during the time delay on entry.
Accepted or ♫
Confirmed
Signal output when a command is accepted or a detector is triggered in detector test
mode:
♫
Error
Signal generated during a code entry error or when a command is refused.
Chime
Signal generated by passing in front of a detector programmed in chime mode.
Audio signals generated by the alarm unit and the siren (option
programmable on settings menu) when using a remote control: remote control
unit or keypad.
Total ♫
supervision on
Signal generated when total supervision is activated.
♫
Supervision off
Signal generated when the alarm unit is turned off.
— ————
———————
— — — —
——————
— — — —
♫ ♫
—— ——
——————
- 16 -
Lit: Battery low
Unlit: Battery OK
Lit: The alarm unit is making a
call to call reception centre
1 short beep + 1 long beep
Time 0.2 sec + 0.6 sec
1 continuous long beep
1 beep every second
1 long beep
Time 1 second
4 rapid beeps
Ding dong
2 beeps
Time 2 x 0.3 seconds
1 long beep
Time 1 second