Sangean PR-D2/V Mode D'emploi page 12

Setting tuning step
Tuning steps on some countries are different from where you
purchase the radio. If you buy the radio in Europe and intend to
use it in Northern America or some Southern American countries,
you may have to adjust tuning step so the radio may continue to
serve you well.
While radio is switched off, press Preset 3 button (Step) for more
than 7 seconds until display FM and 100 kHz (tuning step) are
flashing followed by a beep tone. By pressing Tuning down button,
you may adjust to 50 kHz per tuning step.
After FM tuning step is re-set, press Preset 3 button, display will
show MW and flash 9 kHz. By pressing Tuning up button, you may
adjust to 10 kHz per tuning step. Complete the setting by pressing
Preset 3 button.
Similar thing will happen if you purchase PR-D2V in Northern
America and wish to use it in Europe or other countries. Use same
way as above to change the tuning step to fit your listening area.
DST (Daylight saving time)
While radio is switched off, press Preset 1 button (DST) for more
than 2 seconds to advance the real time for one hour. Display DST
symbol will appear. To be back to normal time, press Preset 1
button for more than 2 seconds until display DST symbol
disappears.
Headphones socket
A 3.5 mm Headphone socket located on the right-hand after Tone
control button of your radio is provided for use with either
headphones or an earpiece. Inserting a plug automatically mutes
the internal loudspeaker.
11