Snooze Function - Sangean PR-D2/V Mode D'emploi

Setting the HWS (Humane Wake System) alarm
A beep tone will sound when using the HWS alarm. The alarm
beep will increase in volume every 15 seconds for one minute
followed by one minute silence before repeating the cycle. The
HWS alarm will sound for one hour unless turned off by pressing
the Power button. Pressing the Power button whilst the alarm is
sounding will cancel the alarm for 24 hours.
1. The HWS alarm can be set with the radio switched off.
2. Press the HWS alarm button (Preset no. 4) until the hour digits
and alarm symbol
tone.
3. Set the required hour using Tuning up/down buttons.
4. Press the HWS alarm button, the minute digits will flash in the
display.
5. Set the required minute using the Tuning up/down buttons.
6. Press HWS alarm button to complete alarm setting.
7. To permanently cancel the alarm, press the HWS alarm button
until the

Snooze function

1. Whilst the alarm is sounding, press any button (except the
Power button) will active the snooze function. The radio or HWS
alarm will be silenced for 5 minutes.
2. The display will flash both the snooze symbol
alarm symbol. The snooze function can be repeatedly during
the 1 hour that the alarms are active.
9
flash in the display followed by a beep
symbol is removed from the display.
and the