ShelterLogic UltraMax Peak Canopy Instructions De Montage page 7

step 7
Position the cover on the side of the frame with the side with the grommets parallel to the frame and facing down. Go to
the opposite side of the frame and throw at least three ropes over the frame (evenly spaced along the length of the frame).
Tie the ropes to the grommets on the cover and use the rope to pull the cover over the frame (the more people and ropes
you have to pull the cover over the easier it is to do). Position the cover so that the valance is even front to back and side
to side.
Slide the pocket pipes into the cover pockets between the cutouts. Attach the pocket pipes to the frame using the 3 &
4 way clamps (800220 & 800221) and the 5/16 X 2 1/4 #11130 bolts and nuts. Check that the pocket pipes are evenly
spaced on both sides of the top pipe. Slide the pocket pipe down the length of the rafters to tighten the top section of the
cover. When the cover is pulled tight secure the bolts and nuts in the sliding clamps to hold them in place.
800220
11130
800230
00690
End Rib
Fig. 7A
Slide the rope through the grommets and around
the side extention tubes at both sides shown
in Fig.7C. Insert the 'S' hook to the
corner leg tube, then 'twist' the leg to tighten the rope
(Fig.7D).
After tightening the rope, secure the (4) corner leg tubes
#800216 to the corner connectors and feet plates with
5
#800218 ( / x 3 in. Bolts) and nuts.
16
step 8
Use the (4) Ratchets as shown in Fig.8A.
Adjust the cover so there is equal overhang
on the front and rear. With the webbing and
ratchets pull the cover snug but not tight.
When all of the half clamps and rope are
secured tight finish tightening the (4) Ratchets
to make final adjustment to the cover.
Fig. 7C
Fig. 8A
Page 7
Middle
800221
Rib
11130
800230
00690
00690
Fig. 7B
Fig. 7D
Fig. 8B
05-27773-0B
800230