ShelterLogic UltraMax Peak Canopy Instructions De Montage page 5

step 1
Assemble the wind brace set as shown in Figure 1.
step 2
See Figure 2A.
Fit together the end rib using the following parts
(1) #800091 3-Way Top Connectors
(2) #800096 Rafter Poles
(2) #800090 Extend tube
(2) #800095 Common Tubes
(2) #800092 3-Way Side Connectors
(1) Wind Brace set
Fig 2B:
Fit together the middle rib using the following parts
(1) #800093 4-Way Top Connectors
(2) #800096 Rafter Poles
(2) #800090 Extend Tube
(2) #800095 Common Tubes
(2) #800094 4-Way Side Connectors
(1) Wind Brace set
/
Using (8) #800218 (
5
16
securely fasten these tubes. Lay these ribs on the
ground at the rear of your shelters designated location.
NOTE: Be sure that all of the heads of the bolts are
facing toward the outside of the rib.
Repeat step 2A/2B for all the other ribs.
step 3
Using #800098 Cross Rails, #800217
/
( x 2 in. Bolts) and Nuts to connect
5
16
these ribs. See Figure 3
step 4
Assemble (2) #800216 Corner Support Tubes and (4) # 800095 middle support tube as shown in Fig. 4A and
set aside. Assemble other side Support Tubes as shown in Fig. 4B and connect the middle support tubes with
/
#800218 ( Bolts) and nuts. Repeat this step at opposite side.
5 x 3 in.
16
Note: #800218 Bolts are required for middle support tube connections. Bolts are NOT inserted to the
corner legs (#800216) at this step.
Fig. 4A
800216
Basic Frame Assembly
Bolts) and (8) Nuts
x 3 in.
800095
Fig. 1
#800103
Fig. 2A:
2 End Ribs
800096
800095
800092
Use #800218 Bolt (
Fig. 2B:
800096
Middle Ribs
800095
800094
Use #800218 Bolt (
800098
800216
800095
Page 5
#800217
#800104
#00690
800091
Wind brace
/
)
5 x 3 in.
16
800093
Wind brace
/
)
5 x 3 in.
16
Fig. 3
Fig. 4B
05-27773-0B