Briteq BT-575W Mode D'emploi page 7

ENGLISH

Once the position has is selected, press the ENTER button to setup OR Automatically return to the offset
functions without any changes by pressing the MENU button
To go back to the main functions without any change wait 8 seconds.
Color offset

Press the MENU button for at least 5 seconds to activate offset mode

Use DOWN and UP button until is shown on the display.

Press the ENTER button so the display starts blinking.

Use DOWN and UP button to adjust the color home position.

Once the color is selected, press the ENTER button to setup OR automatically return to the offset
functions without any changes by pressing the MENU button
To go back to the main functions without any change wait 8 seconds.
Dimmer offset

Press the MENU button for at least 5 seconds to activate offset mode

use DOWN and UP button until the

Press the ENTER button so the display starts blinking.

Use DOWN and UP button to adjust the dimmer home position(0~255).

Once the mode has been selected, press the ENTER button to setup or automatically return to the offset
functions without any change press the MENU button again.
To go back to the main functions without any change after 8 seconds.
HOW TO CONNECT THE UNIT BY DMX
The DMX-protocol is a widely used high speed signal to control intelligent light equipment.
You need to "daisy chain" your DMX controller and all the connected light effects with a
good quality XLR M/F balanced cable. To prevent strange behavior of the light effects, due
to interferences, you must use a 90Ω to 120Ω terminator at the end of the chain. Never
use Y-splitter cables, this simply won't work!
Each light effect in the chain needs to have its proper starting address so it knows which commands from the
controller it has to decode.
BRITEQ
®
OPERATION MANUAL
is shown on the display.
9/68 BT-575W
ENGLISH
 HOW TO SET THE THE RIGHT STARTING ADDRESS:
Refer to the previous chapter (DMX-512 address setting) to learn how to set the starting address on this unit.
The starting address of each unit is very important. Unfortunately it is impossible to tell you in this user
manual which starting addresses you have to set because this completely depends on the controller you will
use... So please refer to the user manual of your DMX-controller to find out which starting addresses you
must set.
DMX-CONFIGURATION OF BT-575W:
16 channel modus
BRITEQ 10/68
®
OPERATION MANUAL
BT-575W