Table des Matières
Publicité
1. Precaution and safety rules.
Read carefully this manual before installing the apparatus and meticulously follow the instructions during the installation and its very use.
Keep this manual for future consultations regarding the functioning of the Skimmer.
Never run the filter when there are people in the pool.
The filter has been projected and reallzed for above ground fresh water domestic pools.
Filters equipped with a transformer (12 [V]) may be placed at the edge of the pool but electrical connections of the transformer must be at least 3.5
[m] from the edge of the pool.
Make sure the electrical plant complies with international prescriptions in force.
Check whether the product is compatible with the characteristics of your electrical plant.
Never pull the electrical cable. lf the cable is damaged, the product must be demolished.
The pump cable must be connected to the power supply by a 30 [mA] differential switch.
Do not operate the apparatus without water.
Do not ever tauch the operating apparatus with wet hands or body or put hands in water while the pump is running.
Always disconnect the electrical input tap when the apparatus must be handled.
Make sure the pavement is dry before handling the electrical system.
Do not place the apparatus where it can get wet, since it can cause electroshock.
Do not allow children or adults to lean against or to sit on the apparatus.
Once the filter is installed, its plug must be easily accessible
lf the electrical cable is damaged, it can not be replaced and the pump must be scrapped.
Only for domestic use.
Do not let children play with the appliance, e.g. do not allow them to sit in the drawers or swing on the door. This appliance is not intended for use by
persons (including children) with reduced physical, sensory or mental capabilities or lack of experience and knowledge unless they have been given
initial supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that
they do not play with the appliance.
Maximum water temperature: 35 [°C].
Minimum water temperature: 4 [
0
C].
2. Package componets.
The Skimmer that you have just purchased is a highly functional device with an innovative design, it consists of diffferent components which are
..
Quant.
Denomination
1
Float.
1
Body.
1
Base.
1
Filterframe.
3
Filterina foams.
Models eouipped with foams).
1
Cartridae.
Models eouipped with cartridael.
1
Hook.
Adiustable, Flexil.
1
Suooort rod.
Pool in sheet metal or tube l.
1
Support clamo.
Pool in sheet metal or tubel.
2
Support fastener knob.
Pool in sheet metal or tube).
2
Support fastener nut.
Pool in sheet metal or tube).
1
Support rod hook.
Self-bearina Pool.
2
Rod stoP.
2
Finned fastenina screws and was her.
1
Transformer.
-
Tab.3.
Make sure that the equipment includes all the components.
3. Description (Fig. 1).
1. Float.
8.
Pump support
14. Support clamp.
2.
Body.
9. Pump.
15. Knob.
3.
Base.
10. Rod hook.
16. PVC washer.
4. Frame.
11. Support rod.
17.
Nut.
5.
Sponges.
12. Rod stop.
18. Transformer.
6.
Cartridge.
13. Fins+washer.
4. Installation.
4.1. Necessary for a correct installation.
Due to an easy installing form, this apparatus can be assembled by ONE ADULT PERSON, in about Y, HOUR, carefully reading and correctly following
the instructions indicated in the manual.
4.2. Positioning.
Position the Skimmer in the direction of the strengest winds; this favors the transport of dirt that remains on the surface of the pool towards the filter. The
transformer must be installed at least 3.5 [m] from the edge of the pool. See the drawing (Fig. 3).
4.3. lnstallatio oft he support:
Insert the support rod into the body seating and fasten it with the nuts and throttle valves (Fig. 4).
Bring the group (body+support) to the edge of the pool.
Adjustable hook: loosen the two support fastener knobs to open the ciamp and put it half-way on the edge of the pool. Then tighten the two support
fastener knobs until they are correctly fastened on the edge (Fig. 5a).
Flexi hook: press on the ftoat ofthe self-bearing pool and put it in the support hook (Fig. 5b).
In each case, balance the apparatus so that it remains in a vertical position (Fig. 6).
4.4. Levelling and fastening the skimmer:
•
The apparatus must be well-levelled for it to function correctly.
For this pur pose loosen the throttle valves and make the Skimmer slide until the float is suspended on the water. (Fig. 6).
Once it is positioned, fasten it by tightening the throttle valves.
4.5. Positioning the foams (for models equipped with foams):
Take the float and the frame out of the body of the Skimmer.
Place the foams in the upper part of the Skimmer in the correct order, starting from the one with the smallest holes, and finishing with the one with
biggest holes, in such a way that the latter remains on top. (Fig. 6).
Press until the foams are properly inserted in the Skimmer.
File name: 85.10.06N - ISTR. SKI MM ER 7 LINGUE
Rev. 2 of 26/01/2012
Page 6-of 28
8. Garanti.
8.1. Allmänt.
i.
Enlighet med denna bruksanvisning garanterar äterförsäljare att produkt som innefattas av denna garanti är felfri vid leverans.
ii.
Garantitid är tvä (2) är trän och med datum dä produkten levereras till kund.
iii.
Om kunden upptäcker fel som täcks av garantin i produkten under garantitiden skall kunden anmäla det till äterförsäljaren. Aterförsäljare
tär
laga eller byta ut varan med egen bekostnad och för henne i bäst lämpade utrymme.Förutom om det är omöjligt eller orsakar orimliga
kostnader.
iv.
Om produkt ej gär att laga eller byta ut under garantitid, kan köparen begära fömuftig rabat eller om feiet är stort även häva köpet.
v.
Delar, som under garantitiden möjligen lagas eller bytes ut förlänger ej garantitiden.
vi.
För att garantin skall gälla mäste kunden kunna visa upp kvittot där leverans samt köpdatum framgär.
vii.
1
fallet att köparen anmäler fel mera än 6 mänader efter köpesdatum, skall köparen kunna bevisa orsaken till feiet samt dess existens.
viii.
Dessa garantivillkor begränsar ej konsumentköplagens rättigheter.
8.2. Specialvillkor.
i.
Garanti gäller produkt som handlas i denna manual.
ii.
Garantin gäller endast inom europeiska unionen.
iii.
För alt garantin ska gälla mäste manualen följas.
iv.
Qm nägon komponent har byts ut, gäller garantin endast om bytet har gjorts enligt tillverkarens föreskrifter.
v.
Om för produktens del finns angiven byte/service intervall eller brukbegränsning, gäller garantin endast om manualen har följts.
8.3. Begrnsningar.
Denna garanti tillämpas endast för till konsumenten sälda produkten. "Konsument" är hon, som köper produkten till privat bruk; Garantin
gäller ej vid komersiell bruk.
ii.
Garantin gäller ej vid normal slitage pä till exempel filterpatron.Köparen skall följa användarmanual.
iii.
Garanti gäller ej vid felaktigt handhavande av produkten (1) , (II) produkten har lagats eller servad av obehörig person (III) eller lagats
med andra än orginal reservdelar. Om feiet har framkommit beroende pä felaktigt installering eller bruk, gäller garantin endast om det
har av äterförsäljaren gjorts en separat köpeskontrakt där äterförsäljaren har ätagit sig ansvaret för garantin.
Filename: 85.10.06N - ISTR. SKIMMER 7 LINGUE
Rev. 2 0126/01/2012
Page 23-of 28
Publicité
Chapitres
Table des Matières
