Bestron AF357B Mode D'emploi page 23

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 15
instruction manual
The fryer will now start melting the blocks of fat at a low temperature at which point some smoke may
appear. This is not out of the ordinary. Make sure the room is properly ventilated.
NEVER set the temperature above 130 degrees Celsius during this procedure. It will cause the heating
element to overheat, which will not be able to discard the heat it generates and that will activate the
overheating safeguard.
oPerAtion - overheating safeguard
You can use the deep fryer only when it is filled with oil or fat. Do not use the
appliance if the bowl is empty or does not contain sufficient oil or fat. The deep
fryer is equipped with an overheating safeguard. This will be activated if the
temperature is rising, for example, you use the appliance without (sufficient) oil or
fat. Should this happen, you have to rest the deep fryer.
1. Switch off the deep fryer by turning the On/Off - temperature control knob
completely to the left. Disconnect the plug from the wall socket.
2. Allow the appliance to cool down completely.
3. Reset the appliance by pressing with a long (min. 6cm long) nonmetal pin
against the reset switch in the hole at the backside of the pane.
oPerAtion - Placement of the handle
1. Please fit the ends (A) of the handle into the
eyes of the basket
2. Move the handle upwards and press it until it
locks to the basket (B)
3. The handle is placed correctly and is now ready
for safe use (C)
oPerAtion - deep frying
You can use the deep fryer to fry ingredients at the temperature you require.
1. Place the appliance on a stable, flat, heat-resistant surface.
2. Remove the lid
3. Remove the frying basket.
4. Put the lid on the fat fryer.
5. Put the plug into the wall socket.
6. Turn the temperature control knob to the required setting. The temperature pilot light (3) will illuminate.
This indicator light shows that the heating element has been switched on, but that the required
temperature has not been reached. The required temperature has been reached once the "heating"
indicator light extinguishes.
When setting the temperature take account into the food you intend to fry. Pre-cooked or pre-fried food
(such as deep-freeze chips or potato rissoles) will need to be fried at a higher temperature than food
that has not been pre-cooked or pre-fried. See Table 1 or the table on the panel of the deep fryer for an
indication of the frying temperatures and times.
7. Lower the filled frying basket gently into the deep fryer and put the lid on the fat fryer.
8. Once the food is ready open the lid completely to ensure that you will not get burnt by the escaping
steam. Remove it gently from the bowl. You can use the hook fitted to the frying basket to hang it on
the inner rim of the bowl; the excess oil can then drip from the frying basket. Then carefully place the
food on a plate or in a bowl.
9. When you have finished frying switch off the deep fryer by rotating the On/Off-temperature control knob
fully to the left (to the 'Off' position). Disconnect the plug from the wall socket.
Make sure that the food is thoroughly dry before you fry it. Moist products can cause severe
A
23
Restart
C
C
B

Publicité

Table des Matières
loading

Table des Matières