Familiarise Yourself With The Appliance; The Control Panel; The Hotplates; Residual Heat Indicator - CONSTRUCTA CA4 13 Série Mode D'emploi

Absence of pan or unsuitable size
If no pan is placed on the selected hotplate, or if it is made of
unsuitable material or is not the correct size, the power level
displayed on the hotplate indicator will flash. Place a suitable
pan on the hotplate to stop the flashing. If this takes more than
90 seconds, the hotplate will switch off automatically.
Empty pans or those with a thin base
Do not heat empty pans, nor use pans with a thin base. The
hob is equipped with an internal safety system. However, an
empty pan may heat up so quickly that the "automatic switch

Familiarise yourself with the appliance

These instructions for use are applicable to other hobs. On
page 2 an overview of the models is provided, along with
information on measurements.

The control panel

# FKLOGSURRI ORFN
Control surfaces
Pressing a symbol activates its corresponding function.

The hotplates

Hotplate
$ Single hotplate
æ Grill zone
q Resistive plate-warming zone*
* Activating the hotplate: The corresponding indicator lights up.
** The residual heat warning light comes on.
Only use cookware suitable for induction cooking; see the section on suitable cookware.

Residual heat indicator

The hob has a residual heat indicator for each hotplate to show
those which are still hot. Avoid touching a hotplate that displays
this.
&RQWURO SDQHO
IRU
&RQWURO SDQHO
IRU
PDLQ VZLWFK
Turning on and off
Always use cookware of a suitable size.
This zone is switched on automatically when using cookware with a base the
same size as the outer zone.
Press the „ symbol.**
off" function may not have time to react and the pan may reach
very high temperatures. The base of the pan could melt and
damage the glass on the hob. In this case, do not touch the
pan and switch the hotplate off. If it fails to work after it has
cooled down, please contact the Technical Assistance Service.
Pan detection
Each hotplate has a minimum limit for detecting pans, which
varies depending on the material of the pan being used. You
should therefore use the hotplate that is most suitable for the
diameter of your pan.
,QGLFDWLRQV IRU
SRZHU OHYHO³É
IXQFWLRQDOLW\ ¯
UHVLGXDO KHDW ¤‡
SRZHUERRVW IXQFWLRQ °
&RQWURO &RQWURO SDQHOV
SDQHO IRU IRU
6 WLPH VHOHFWLQJ SRZHU
OHYHO
SURJUDP
IXQFWLRQ
Notes
The settings will not change if several symbols are pressed at
■
the same time. This enables the programming zone to be
cleaned when food is spilt.
Always keep the control surfaces dry. Moisture can affect
■
proper functioning.
Even when switched off, the œ/• light will remain on as long as
the hotplate remains hot.
If the pan is removed before the hotplate is turned off the œ/•
indicators and the selected power level will appear alternately.
&RQWURO SDQHO
IRU
´ ]SODWHZDUPLQJ ]RQH
19