Maintenance And Cleaning; Storage; Disposal And Recycling - Scheppach WSE5000-Multi Traduction Du Mode D'emploi Original

12. Maintenance and cleaning

Danger!
Disconnect the mains plug before carrying out any
cleaning work.
Note: The welding machine must be serviced and
overhauled regularly to ensure proper operation and
compliance with safety requirements. Improper and
incorrect operation may result in failure and damage
to the device.
• Before carrying out any cleaning work on the weld-
ing device, pull the mains cable 8 out of the socket
so that the device is safely disconnected from the
power supply circuit.
• Clean the outside of the welding device and its ac-
cessories regularly. Remove dirt and dust using air,
a cleaning rag or a brush.
Note: The following maintenance work shall be carried
out only by qualified specialists.
• Current regulator, earthing device, internal wiring,
the welding torch coupling device and adjustment
screws should be serviced regularly. Retighten
loose screws and replace rusty screws.
• Regularly check the insulation resistances of the
welding device. Use the appropriate measuring de-
vice for this purpose.
• In the event of a defect or if it is necessary to replace
parts of the device, please contact the appropriate
specialist personnel.
The device has no further internal parts that require
maintenance.
Service information
With this product, it is necessary to note that the follow-
ing parts are subject to natural or usage-related wear,
or that the following parts are required as consuma-
bles.
Wearing parts*: Electrode holder, earth clamp, current
nozzle, burner nozzle
* may not be included in the scope of supply!
Spare parts and accessories can be obtained from our
service centre. To do this, scan the QR code on the
cover page.
40 | GB

13. Storage

Store the device and its accessories in a dark, dry and
frost-free place that is inaccessible to children. The op-
timum storage temperature lies between 5 and 30 ˚C.
Store the power tool in its original packaging. Cover the
power tool to protect it from dust or moisture. Store the
operating manual with the power tool.

14. Disposal and recycling

The device is supplied in packaging to avoid
transport damages. This packaging is raw ma-
terial and can thus be used again or can be
reintegrated into the raw material cycle.
The device and its accessories are made of
different materials, such as metals and plas-
tics. Take defective components to special waste dis-
posal sites. Check with your specialist dealer or munic-
ipal administration!
Old devices must not be disposed of with house-
hold waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and
electronic equipment (WEEE). This product must be
handed over at the intended collection point. This can
be done, for example, by returning it when purchasing
a similar product or delivering it to an authorised collec-
tion point for the recycling of old electrical and electron-
ic devices. Improper handling of waste equipment may
have negative consequences for the environment and
human health due to potentially hazardous substances
that are often contained in electrical and electronic
equipment. By properly disposing of this product, you
are also contributing to the effective use of natural re-
sources. You can obtain information on collection
points for waste equipment from your municipal admin-
istration, public waste disposal authority, an authorised
body for the disposal of waste electrical and electronic
equipment or your waste disposal company.
www.scheppach.com