Marmitek MegaView 91 Mode D'emploi page 5

4. INSTALLATION
In order to check proper functioning of the system, it is advisable to test the
set-up first, using a short CAT-5e/6 cable.
1. Switch off all appliances before you start connecting.
2. Connect the HDMI source (Blu-ray disc player, TV Decoder, Media
Centre PC, etc.) to the MegaView 91 transmitter [1], using an HDMI
cable (not provided).
3. Optional: connect an HDTV to the MegaView 91™ transmitter [2] with
an HDMI cable to HDMI OUT, to be able to continue to watch TV in this
room.
4. Connect your HDTV or HD projector to the MegaView 91™ receiver [3]
with an HDMI cable to HDMI OUT.
5. Use one CAT5e/6 Ethernet cable to connect the MegaView 91's
transmitter to the receiver [4].
x
The MegaView 91™ can either be connected by using a single
cable, or through an existing home network (LAN) in combination
with network switches and routers.
6. Repeat steps 4 and 5 to connect additional receivers.
7. Connect the power adapter [5] to the '5VDC' connection on the
MegaView 91™ and plug the adapters into a socket.
Attention! Do not place the MegaView 91™ transmitter or receiver in an
enclosed space, such as a TV cabinet or equivalent. Provide adequate
ventilation to ensure that the product is functioning properly and to protect
against overheating.
MegaView 91™ 5