Advanced operation
Pairing with other Bluetooth devices
What is pairing?
Bluetooth devices need to be "paired" with each other beforehand.
Once Bluetooth devices are paired, there is no need for pairing
again, except in the following cases:
Pairing information is deleted after repair, etc.
This product is paired with 9 or more receiving devices.
This product can be paired with up to 8 Bluetooth device
respectively. If a new device is paired after 8 devices have been
paired, the device whose latest connection time is the oldest
among the 8 paired devices is replaced by the new one.
This product is initialized.
All pairing information is deleted (page 38).
Pairing transmitter with other Bluetooth receiving devices
1
Turn on the power of iPod.
(Make sure the iPod is in pause mode.)
2
Connect the transmitter to the iPod (page 16).
3
Place the transmitter and the Bluetooth receiving device to be
paired together within 1 m (3 ft).
4
Set the Bluetooth receiving device to enter "Pairing in process."
See the operating instructions supplied with the Bluetooth receiving
device.
Notes
Passcode* of the transmitter is fixed at "0000", "1234", or "8888." Depending
on the Bluetooth receiving device, it may be necessary to input the passcode
(in this case, "0000", "1234", or "8888"). The transmitter cannot be paired
with a Bluetooth receiving device whose passcode is not "0000", "1234", or
"8888."
If the Bluetooth receiving device requires a passcode, input "0000."
* Passcode may be called "Passkey, " "PIN code, " "PIN number, " or "Password. "
Continued
21
US