b) Cleaning the air filter
• Clean the air filters (6, 8) regularly every 2 weeks to ensure that the air conditioner remains efficient.
• First pull the upper air filter (6) on the back out to the side (insert your finger in the recessed grip). Then remove
the lower air filter (8).
• Clean the air filters (6, 8) with a vacuum cleaner. If the filters are very dirty, wash them with warm water
(approx. 40 °C) and a mild detergent. Allow them to dry before installing them again.
• Then re-install the air filters correctly.
Never operate the appliance without the air filters.
15. Maintenance
Switch off the appliance before all maintenance and remove the mains cable (11) with plug from the mains
socket.
a) Emptying the condensate tank
• Empty the condensate tank if the warning devices (warning sound and flashing of the backlight) indicate this is
necessary or if you are planning not to use the product for a long period of time.
• Unplug the mains plug from the mains socket.
• Remove the cover (10) from the discharge outlet (12).
• Remove the rubber plug (9) from the discharge outlet (10). The water flows out immediately. Allow all the water to
flow out. If necessary, use a drain hose or place a container under the discharge outlet (12). Neither of these are
included with this product.
• Drain the water into a suitable container, outdoors or into another suitable drain.
• Only allow the condensate to run directly onto the floor if there is a good floor drain and the floor is water resistant
(for example, not on wooden floors).
b) Cleaning at the end of the season
• Remove the cover (10). Remove the rubber plug (9) from the discharge outlet (12). The water flows out immediately.
Allow all the water to flow out. If necessary, tilt the appliance slightly to one side to allow all the water to flow out.
• Refer to the information in section 15. Maintenance a) Emptying the condensate tank.
• Run the appliance at low fan speed for approx. 1/2 day up after it has been fully emptied until it has fully dried. This
prevents the formation of mould in the interior of the appliance during storage.
• Then switch the appliance off with the
socket.
• Wind the mains cable (11) carefully, fasten it with a suitable tie (wire, string) and put the plug in the plug holder (13).
• Remove all air hoses etc. and store them in such a way that they are protected and dry.
• Cover the appliance and store it in a dry place. Use the original packing material for this, if necessary, to protect
the environment.
• Remove the batteries from the remote control and store them safely or recycle them according to the statutory
provisions.
POWER button (21) and unplug the mains plug (11) from the mains
39