Technical Data; Technical Information - PROLUMIA PRODISC Manuel D'utilisation

ATTENTION
Please read the following instructions carefully to ensure that mounting operation will be carried out correctly. These instructions
should be properly preserved for future reference.
CAUTION
1. The product must be installed by qualified technicians. The power supply must be cut before installation.
2. The installation wiring must be 2x 1.0 mm² at least and wired in accordance with the latest IEE electrical regulations or the national requirements.
(Recommended type of cable is H03VV-F)
3. Cut the power supply before replacing battery.
4. Do not touch the electronic circuit and its components.
5. When fixture is unable to maintain the 1 hour duration under battery operation, then the battery must be replaced.
6. Contact an authorised technical service center for the replacement of the battery and use only original manufacturer spare parts for any
other repairs.
7. Code for identification of battery production date: ex.1810 --- 2018, week10.
8. Do not touch the LEDs while installing or maintaining.
9. This product contains a light source of energy efficiency class D.
10. The charge of the battery will decrease by self-discharge if not connected to mains supply. Prolonged periods without voltage can damage the
battery. Battery warranty claims, as a result of such abuse, are specifically EXCLUDED from warranty terms.
11. On many building sites, power circuits may be cut off in an uncontrolled and repetitive basis during construction. As a result, any unit on
these circuits, will have their batteries discharged or 'cycled' . Excessive battery cycling will reduce through-life performance and may lead to
premature battery failure. Battery warranty claims, as a result of such abuse, are specifically EXCLUDED from warranty terms.

TECHNICAL DATA

Supply voltage: AC 220-240V 50/60Hz
Light source: LED SMD2835
Battery: Ni-Cd Duration: 1 hour
Operating temperature: -10°C – +50°C (Sensor version: -10°C – +40°C)
Color temperature switchable: 3000K / 4000K

TECHNICAL INFORMATION

Article no. Voltage
40009322 220-240V 50/60Hz
40009332 220-240V 50/60Hz
MICROWAVE SENSOR - DESCRIPTION
Detection angle: 30° - 150°
Detection range: 12m - 18m (diameter), adjustable
Time setting: 5sec - 30min, adjustable
Daylight level: 2Lux - 50Lux, adjustable
Mounting height: Max. 10m
LED type Power Max. light output
SMD2835 13W 1300Lm
SMD2835 14W 1300Lm
www.prolumia.com
ø 348
Max. light output
MW sensor
emergency mode
280Lm -
280Lm Yes
Detection range (m)
10 9 8 7 6 5 4 3 2 1 0 1 2 3 4 5 6 7 8 9 10
1
2
3
4
5
6
7
8
9
10
11
12
13
14
Area of high sensitivity
Area of lower sensitivity
Max. slaves
-
19 pcs
9