Cable Connection - PROLUMIA PRODISC Manuel D'utilisation

MOUNTING
There are two ways to mount the fixture.
A. Surface mounting
(Put the fixture onto the surface directly)
1. Disassemble the diffuser and LED panel.
2. Pull the power cord through the gasket.
3. Fix the fixture on the surface with screws.
4. Connect the power cord on the terminal correctly.
5. Connect the plug of the battery firmly onto
the emergency driver.
6. Assemble the LED panel and diffuser.
B. Semi-recessed mounting
(Put the fixture into the ceiling hole reserved in advance)
1. Make a hole (a little larger than the fixture base) into surface.
2. Disassemble the diffuser and LED panel.
3. Fix the metal frame into the hole in the ceiling.
4. Disassemble the diffuser and LED panel, then fix the base on the
metal frame with 2x M4 screws.
5. Pull in the power cord through the gasket.
6. Connect the power cord on the terminal correctly.
7. Connect the plug of the battery firmly onto
the emergency driver.
8. Assemble the LED panel and diffuser.

Cable connection

MAINS POWER SUPPLY
Remove wire bridge when externally switched
Uninterrupted mains supply (for emergency backup function)
Emergency mode version
Remove wire bridge when externally switched
Uninterrupted mains supply (for emergency backup function)
Emergency mode + Sensor version
(switched phase not required)
www.prolumia.com
2
3
5
4
Cable
1 6
3 5
7
4
6
Cable
2 8
MAINS POWER SUPPLY
Metal frame
1
13