Milwaukee 0613-20 Manuel De L'utilisateur page 8

Positions
1 - 5
6 - 10
11 - 15
16 - 20
Drill
L o w
High
NOTE: Because the above settings are only a guide, use a
piece of scrap material to test the different clutch posi-
tions before driving screws into the workpiece.
Selecting Speed (Fig. 5)
Fig. 5
L o w
The speed selector is on top of the motor
housing. Allow the tool to come to a com-
plete stop before changing speeds. See
"Applications" for recommended speeds
under various conditions.
1. For Low speed (up to 500 RPM), push
the speed selector forward.
2. For High speed (up to 1700 RPM), push
the speed selector back.
Selecting Hammer or Drill Action
(Cat. No. 0613-20, 0614-20, and 0624-20 only)
MILWAUKEE Hammer-Drills are designed
for two operating modes: drilling with ham-
mering action and drilling only. To set the
operating mode, rotate the torque selector
collar to the desired symbol. A drill or ham-
mer symbol will appear in line with the ar-
row to indicate operating mode.
1. To use the hammer-drilling mode,
rotate the torque selector collar until
the hammer symbol
0614-20 &
0616-20 0613-20
Torque Torque
0 - 17 in. lbs.
0 - 17 in. lbs.
21 - 38 in. lbs.
21 - 38 in. lbs.
42 - 60 in. lbs.
42 - 60 in. lbs.
65 - 85 in. lbs.
65 - 85 in. lbs.
350 in. lbs
460 in. lbs.
120 in. lbs.
160 in. lbs.
High
appears in
8
0622-20 &
0624-20
Torque
0 - 17 in. lbs.
21 - 38 in. lbs.
42 - 60 in. lbs.
65 - 85 in. lbs.
495 in. lbs.
175 in. lbs.
line with the arrow. Apply pressure to
the bit to engage the hammering
mechanism.
2. To use the drilling only mode, ro-
tate the torque selector collar until the
drill symbol
the arrow.
NOTE: When using carbide bits, do not use
water to settle dust. Do not attempt to drill
through steel reinforcing rods. Both ac-
tions will damage the carbide bits.
Using Control Switch (Fig. 6, 7 and 8)
The control switch may be set to three
positions: forward, reverse and lock. Due
to a lockout mechanism, the control switch
can only be adjusted when the ON/OFF
switch is not depressed. Always allow the
motor to come to a complete stop before
using the control switch.
For forward (clockwise) rotation, push in
the control switch from the right side of the
tool (Fig. 6). Check the direction of
rotation before use.
Fig. 6
appears in line with
Push in
for forward