Safety Notes; Installation Instructions; Technical Data; Symbol Description - Hansgrohe Raindance Connect Showerpipe Mode D'emploi / Instructions De Montage

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 3
6

Safety Notes

6 Gloves should be worn during installation to prevent
crushing and cutting injuries.
6 The arm of the shower head is intended only to hold
the shower head. Do not load it down with other
objects!
6 Children as well as adults with physical, mental and/
or sensoric impairments must not use this shower
system without proper supervision. Persons under
the influence of alcohol or drugs are prohibited from
using this shower system.
6 Do not allow the streams of the shower touch
sensitive body parts (such as your eyes). An
adequate distance must be kept between the shower
and you.
6 The product may not be used as a holding handle. A
separate handle must be installed.
6 The shower system may only be used for bathing,
hygienic and body cleansing purposes.

Installation Instructions

• The fitting must be installed, flushed and tested after
the valid norms!
• Where the contractor mounts the product, he should
ensure that the entire area of the wall to which the
mounting plate is to be fitted, is flat (no projecting
joints or tiles sticking out), that the structure of the wall
is suitable for the installation of the product and has
no weak points. The enclosed screws and dowels
are only suitable for concrete. For another wall
constructions the manufacturer's indications of the
dowel manufacturer have to be taken into account.
• If required, the bottom part of the pipe between the
fixture and the shower head can be shortened with a
fine-toothed saw.
• The mesh washer must be insert to protect the
overhead shower against incoming dirt by pipework.
Incoming dirt leads to defects or/and can damage
parts of the shower; such caused faults voids all
liability and guarantee claims.
• The shower may only be connected following
(downstream from) a shut-off valve of the sanitary
fitting.
4
English
• The installation dimensions stated in this installation
instructions are ideal for people of approximately
1800 mm in body height. The dimensions can be
altered if required. In this case you will have to attend
to the minimum height of 2190 mm from shower tray
floor, and alter all the required measurements as
necessary.

Technical Data

Operating pressure:
Recommended operating pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
anti-pollution function

Symbol description

Assembly
see page 31
corner fitting set
see page 34
Do not use silicone containing acetic acid!
Adjustment (see page 42)
Spare parts (see page 44)
Dimensions (see page 38)

Flow diagram

(see page 41)
overhead shower
hand shower
Operation (see page 43)
Cleaning (see page 46) enclosed
brochure
Test certificate (see page 45)
max. 0,6 MPa
0,1 – 0,4 MPa
60 °C

Publicité

Table des Matières
loading

Table des Matières