Replacing The Batteries; Manually Setting The Date/Time; Backlight - Hama EWSC-100 Mode D'emploi

4.2 Replacing the batteries

• Remove and dispose of any used batteries. Insert the new battery
(AAA). Ensure that the polarity of the battery corresponds to the
symbols in the battery compartment (12).
5. Installation
You can either stand the weather station on an even surface using the
fold-out stand (11) on the back of the device, or attach it to a wall using
the opening (10) on the back of the device.
Note
• In order to measure the temperature outside, the outdoor sensor (9)
must be located outside of the building.
• Ensure that the outdoor sensor is protected from direct sunlight
and rain.
• Note that the maximum distance between the thermometer and the
outdoor sensor (9) is approximately 135 cm due to the length of the
cable. For this reason, we recommend placing the thermometer near
a window or a door.
• Ensure that the outdoor sensor cable is not bent, placed on sharp
edges or otherwise damaged.
Warning
Before mounting, check that the wall you have chosen is suitable for
the weight to be mounted Also make sure that there are no electric,
water, gas or other lines running through the wall at the mounting
site.
6. Operation

6.1 Manually setting the date/time

Time/date
• Press and hold the MODE button (7) for approximately 3 seconds until
the year ashes.
• Press the UP (5) or DOWN (4) button to select the individual values.
• Set the following information in the order listed:
• year, month, day, hours, minutes
• Press the MODE button (7) to adopt the setting value displayed.
Note
Hold down the UP-button (5) or the DOWN button (4) to select the
values faster.
Note
• The weekday is set automatically when setting the date manually.
• If you do not make an entry for several minutes, you automatically
exit the setup mode. The settings that were made up to that point
are not saved!
Selecting 12 or 24-hour format
• Press the UP button (5) to switch between the 12 and 24-hour
formats. In the 12-hour format, 'PM' is displayed before the time.
Setting the alarm time
• Press and hold the Alarm button (6) to switch to the alarm settings.
• The hours display begins to ash. Use the UP (5) or DOWN (4) button
to set the alarm time.
• Press the Alarm button to con rm your settings.
• If you do not press the Alarm button within 30 seconds, the weather
station automatically switches to normal mode.
Activating/deactivating the alarm
• Press the Alarm button (6) repeatedly to activate/deactivate the alarm.
• The alarm time now appears on the display.
• Press the Alarm button (6) once more. The alarm symbol
displayed, meaning that the alarm is activated.
• Pressing the Alarm button (6) once more will deactivate the alarm.

6.2 Backlight

• If you press the LIGHT button (8), the display lights up for approx.
3 seconds.
is
3