Publicité
Les langues disponibles
Les langues disponibles
• Do not run the power cord over sharp edges and make sure that it does
not get trapped.
• Do not pull the plug from the socket with wet hands or by holding on to
the power cord.
• Do not use the appliance in immediate vicinity of a bath tub, a shower or a
swimming pool (observe a minimum distance of 3 m). Place the appliance
such that a person in the bath tub cannot touch the appliance.
• Do not place the appliance near a heat source. Do not subject the power
cord to direct heat (such as a heated hotplate, open flames, hot iron sole
plates or heaters for example). Protect power cords from oil.
• See to it that the appliance is properly positioned to ensure a high stabil-
ity during its operation and make sure that no one can trip over the power
cord.
• The appliance is not splash-proof.
• For indoor use only.
• Do not store the appliance outdoors.
• Store the appliance in a dry place inaccessible to children (pack the ap-
pliance).
• Prior to any maintenance, cleaning and after each use, switch off the ap-
pliance and unplug the mains cable from the socket.
• Repairs to electrical appliances must only be carried out by a qualified
electrical technician.
• Only use the adapter provided by the manufacturer.
Setting up / operation
1. Place Peter little in the desired location on a flat surface. Connect the
power adapter (1) to the appliance (2) and insert the adapter into a suit-
able mains socket.
2. Switch on the appliance by pressing the On/Off button (3). The appli-
ance gives an audible signal when a setting is changed via the control
panel (4).
3. Press the button for the selection of the speed level (5) to change the
fan speed (levels 1–4). Pressing once increases the speed by one level.
If you would like to increase the speed by another level, press again.
4. Activate swing mode by pressing the swing mode button (6). The appli-
ance now swings at an angle of approx. 70° to ensure optimum distribu-
tion of cooling air throughout the room. Press the swing mode button (6)
again if the appliance is to remain at a certain angle.
5. Press the button for the selection of "Natural Breeze" mode (7) for natu-
ral wind conditions. The blue LED beneath the button (7) will now light
up. This mode provides an even more pleasant cooling effect, simulat-
ing a natural breeze. The fan speed of this breeze automatically varies
depending on the selected speed level.
6. Switch off the appliance by pressing the on/off button (3).
Cleaning
Prior to any maintenance, cleaning and after each use, switch off the appli-
ance and unplug the mains cable (1) from the socket.
Attention: Never submerge the appliance in water (danger of short-circuit).
• For external cleaning, rub with a damp cloth and then dry thoroughly.
Publicité
