Warnings And Precautions; Product Information; General - aerauliqa AIRQURE-P1 Manuel D'installation, D'utilisation Et D'entretien

2 WARNINGS AND PRECAUTIONS

The installation and service of the unit and complete ventilation system must be performed
by an authorized installer and in accordance with local rules and regulations.
Transport and storage
• Do not leave the device exposed to atmospheric agents (rain, sun, snow, etc.).
• Duct connections/duct ends must be covered during storage and installation.
Installation
• A fter removing the product from its packaging, verify its conditions. Do not leave packaging within the reach of children or
people with disabilities.
• B eware of sharp edges. Use protective gloves.
• T he device should not be used as an activator for water heaters, stoves, etc., nor should it discharge into hot air/fume vent
ducts deriving from any type of combustion unit or tumble dryer.
• I f the environment in which the product is installed also houses a fuel-operating device (water heater, methane stove etc., that
is not a "sealed chamber" type), it is essential to ensure adequate air intake, to ensure good combustion and proper equipment
operation.
•If the supply cord is damaged, it must be replaced by the manufacturer, its service agent or similarly qualified persons in order
to avoid a hazard.
• T he electrical system to which the device is connected must comply with local regulations.
• B efore c onnecting the product to the power supply or the power outlet, ensure that:
- the data plate (voltage and frequency) correspond to those of the electrical mains;
- the electrical power supply/socket is adequate for maximum device power.
• F or installation an omnipolar switch should be incorporated in the fixed wiring, in accordance with the wiring rules, to providea
full disconnection under overvoltage category III conditions (contact opening distance equal to or greater than 3mm).
• E nsure adequate air return into the room in compliance with existing regulations in order to ensure proper device operation.
• I nstall the product so that the impeller is not accessible from the air outlet side as verified by contact with the Test Finger (test
probe "B" of the norm EN61032) in compliance with the current safety regulations.
Use
• T he device should not be used for applications other than those specified in this manual.
• T his appliance can be used by children aged from 8 years and above and persons with reduced physical, sensory or mental
capabilities or lack of experience and knowledge if they have been given supervision or instruction concerning use of the
appliance in a safe way and understand the hazards involved. Children shall not play with the appliance.
Cleaning and user maintenance shall not be made by children without supervision.
• D o not touch the appliance with wet or damp hands/feet.
• T he device is designed to intake clean air only, i.e. without grease, soot, chemical or corrosive agents, or flammable or explosive
mixtures.
• D o not use the product in the presence of inflammable vapours, such as alcohol, insecticides, gasoline, etc.
• T he system should operate continuously, and only be stopped for maintenance/service.
• D o not obstruct ducts or grilles to ensure optimum air passage.
• D o not immerse the device or its parts in water or other liquids.
• O perating temperature: 0°C up to +40°C.
Service
• Although the mains supply to the unit has been disconnected there is still risk for injury due to rotating parts that have not come
to a complete standstill.
• Beware of sharp edges. Use protective gloves.
• Use original spare parts only for repairs.

3 PRODUCT INFORMATION

3.1 General

The AIRQURE P1 model is a loft mounted whole-house Positive Input Ventilation unit, designed to introduce fresh, clean, filtered
and (eventually) heated air into the central hallway or landing of a dwelling.
No need of ducting system.
Suitable for floor or ceiling installation, in any position.
The AIRQURE P1-H model is equipped with an integrated heating element.
Make sure that the mains supply to the unit is disconnected before
performing any installation, service, maintenance or electrical work!
If any abnormality in operation is detected, disconnect the device from
the mains supply and contact a qualified technician immediately.
WARNING
13