OK. OBH 26321 Mode D'emploi page 19

TIMER
The timer can be used as a kitchen timer with alarm function or as a timer. The max. adjustable time is 99
minutes.
With a single tap of the +/– button the value changes by 1 minute. Keep the +/– button pressed, the
value changes with 10-minutes increments.
11 Using the timer as kitchen timer
Note: The kitchen timer function can be used with hotplates off, i.e. without cooking.
1. Turn on the glass ceramic cooktop with the switch
2. Use the Timer +/– buttons to set the desired time. The value has been set, the display will flash
for 5 seconds and then the time starts to count down.
• To reset the timer to – push the + and – buttons at once.
• If time is over, the display shows "--" and you will hear a beep sound for 30 seconds. Press any
button to turn off the beep.
12 Timer function for switching off hotplates
Note: In this mode, a hotplate will automatically turn off after a preset time elapsed. When using
several hotplates simultaneously, the timer function applies to the last selected hob.
1. Turn on the glass ceramic cooktop with the switch
2. Set the power level of the relevant hotplate.
3. Thereafter and within a few seconds when the power level flashes on the display set the timer to
the desired time.
• Once the value has been set, the display will flash for 5 seconds and the time count down
starts.
Note: The timer controlled hotplate is indicated by a red dot at the bottom of the
corresponding power level display.
• If the time is over – is shown in display and the corresponding hotplate is switched off.
• Note: Once the timer is activated, the time cannot be changed without reset. Reset the
timer to -- by pushing both + and – timer buttons. Thereafter the timer can be set again.
13 Key Lock
The cooktop can be locked against unintentional use (e.g. as child protection). If the lock is
activated all control buttons except
• Press the lock button
• Press the lock button
14 Residual heat indicator
All hotplates have a residual heat indicator. If the hotplate is off but still hot,
power level display.
The display turns off when the hotplate cooled down to a safe temperature.
IM_OBH26321_141126_V08_HR.indb 19
19
are locked.
Lo
. The display shows and the controls are locked.
for several seconds to unlock the controls.
.
.
H
is shown in each
EN
26/11/14 9:54 AM