Intended Use; Before First Use - OK. OBH 26321 Mode D'emploi

INTENDED USE

This product is designed for heating and cooking foods in suitable pans or pots. Any other use may result
in damage to product or injuries.
COMPONENTS
A. Hotplate 1800 W
B. Hotplate 1200 W
C. Hotplate 1800 W
D. Lock
E. Power setting +/–
F. Timer +/–

BEFORE FIRST USE

• Remove the product and accessories from the original packaging carefully. For disposal of the original
packaging, follow applicable legal requirements. If you have questions about correct disposal, contact
your local authority.
• Check the package contents for completeness and damage. If the package content is incomplete or
damages can be found, contact your place of purchase immediately.
• After unpacking clean the product, see chapter Cleaning and care.
INSTALLATION
1 For installation pay attention to all dimensions. Prepare a cutout A x B mm into the work plate.
L (mm) W (mm)
590 520
WARNING! Pay attention to the safety clearances to the side and rear. When installing a hob higher
cabinets or room walls are only allowed with a 60 mm distance from the rear and 55 mm distance
from only one side (right or left). There shall be no higher cabinet or wall to the other side (right or
left).
2 Consider the minimum clearances for air circulation inside the kitchen cabinet.
A (mm)
min. 760
WARNING! If a hood is placed over the hob, the safety distance specified by the manufacturer must
be observed.
If no manufacturer's instructions are available or combustible materials (e.g. a wall unit) mounted
above the hob, the safety distance A must be at least 760 mm.
3 If possible connect the hob to the mains before installing the hob to the work plate.
WARNING! Before connecting, all poles of the corresponding circuit must be disconnected from
mains supply. Use suitable measurement equipment to make sure the circuit is disconnected from
mains supply.
The corresponding circuit shall be secured against unintentional reconnection.
The electrical connection must be done by an appropriately trained professional.
• Pay attention to the connection diagram and connect L1, L2, N1, N2 and ground to the terminal
accordingly. Make sure that all cables are firmly fixed.
IM_OBH26321_141126_V08_HR.indb 17
G. Timer
H. Hob ON/OFF
I. Hotplate 1200 W
J. Screws
K. Brackets
L. Power cable
H (mm) D (mm)
55 51
B (mm) C (mm)
min. 50 min. 20
17
A (mm) B (mm)
564 494
D E
Air inlet Air outlet min. 5 mm
EN
X - (mm)
50 (for rear side and for
only one side (left or right)
26/11/14 9:54 AM