Pairing A Bluetooth Device - ION Total PA Guide D'utilisation Rapide

7. Vol – - Decreases the Media Panel source volume.
8. Vol + - Increases the Media Panel source volume.
Note: The remote volume only affects the Media Panel source and works together with the physical
Media Panel volume knob on the unit's rear panel.
9. EQ - Selects one of the following digital EQ presets to use with a Media Panel source:
Note: The digital EQ only works for Bluetooth, USB flash drive, and SD card sources.
• BAS - Bass
• POP - Pop
• V0C - Vocal
• JA2 - Jazz
• CLA - Classical
• COU - Country
• Off - No EQ (factory default setting)
10. 100+ - Jumps ahead by 100 tracks.
11. 200+ - Jumps ahead by 200 tracks.
12. Number keys - Provides channel selection for FM radio stations, and track selection for USB/SD card
sources.

Pairing a Bluetooth Device

1. Turn on your Bluetooth device.
2. Power on Total PA.
3. Select Bluetooth Mode which appears as _ _ _ _ using the Mode button and Total PA will go into
pairing mode to search for Bluetooth devices.
4. Navigate to your Bluetooth device's setup screen, find "Total PA", and connect.
Note: Users should consider updating their device's OS if experiencing trouble with pairing or playing
music.
5. To disconnect pairing, turn off Bluetooth on your device or select "forget this device" from your device.
Note: Maximum range will be achieved when using devices with Bluetooth 4.0.
Troubleshooting
If the sound is distorted: Try lowering the volume control of your sound source or musical instrument.
Also, try to reduce the overall volume of Total PA.
If there is too much bass: Try adjusting the tone or EQ control from Total PA or your sound source to lower
the bass level. This will allow you to play the music louder before clipping (distortion) occurs.
If there is a high-pitched whistling noise when using a microphone: This is probably feedback. Point the
microphone away from the speaker.
If you can't hear the microphone over the music volume: Turn down the music volume from your source.
When I press |<< or >>| it doesn't increment to the next FM station: Short presses of the button will jump
to presets. Hold the button down to seek to the next station.
If the radio station channel is flashing: the unit is currently muted. Unmute to stop the flashing and resume
playback.
If the Bluetooth logo is flashing rapidly: the unit is currently in pairing mode.
If the Bluetooth logo is flashing slowly: a device is paired, but the music is muted. Unmute to stop the
flashing and resume playback.
The USB track # (Example: 001) is flashing slowly: the USB drive music playback is muted. Unmute to
stop the flashing and resume playback.
The LCD shows "NONE": the unit is in USB/SD mode, but there is no USB drive attached or no SD card
inserted.
7