ION Total PA Guide D'utilisation Rapide page 4

Speaker Stand Installation
1. Fully extend the speaker stand tripod legs
on a flat, stable surface. Look in the box
contents under the Styrofoam sheet for the
rubber feet and speaker stand mounting
knob.
2. Raise the mounting pole up to the
appropriate height needed and tighten the
side adjustment knob.
3. Insert the pin into the bottom pin-hole so
the mounting pole stays at your set height.
4. On Total PA, adjust the bottom knob
counter-clockwise so the screw is not
blocking the opening.
5. Line up the Total PA mounting hole with
the speaker stand pole and place on the
pole.
6. Tighten the mounting knob clockwise on Total PA.
4