Protection Devices; Door Interlock Switch; Ped Directive 2014/68/Eu; Acs 753 Handling - Bosch ACS 753 Notice Originale

2.2

Protection devices

The station is equipped with the following protection
devices:
+
High pressure safety valves.
+
A high pressure switch that stops the compressor
when excessive pressure is detected.
WARNING: Tampering with these protection
devices can cause serious injury.
WARNING: Do not modify the high pressure
safety valve or the main settings of the
system. Using the machine differently
than as it was designed compromises its
functionality and invalid the protections it is
equipped with.
CAUTION: Always check the pressure
gauges readings to check that the pressures
are maintained within the limits specified in
the "Technical Data" section.
2.3

Door interlock switch

The interlock switch on the rear service door interrupts
the power supply of the machine when it is open.
WARNING: Do not tamper with the interlock
switch in any way. During normal operation,
the rear service door must always be closed
and the overhead panel installed in position.
Robert Bosch GmbH
Precautions | ACS 753 | 45
2.4

PED directive 2014/68/EU

The machine includes parts subject to PED EU directive
2014/68/EU, Pressure Equipment Directive. PED
directive regulates all the pressurized part defining
for them categories based on volume-pressure ratio
and based on fluid refrigerant type. Those parts then
have not to be anyhow modified nor removed. Under
the responsibility of the owner, the machine and parts
falling in the scope of PED shall be checked either
during commissioning and periodically fulfilling local
country regulations and norms.
Parts in the scope of PED are:
+
Tank.
+
Pressure relieve valve.
+
High pressure switch.
+
Recovery group.
+
Piping.
i
Call Bosch service center to get technical specifi-
cations for each part listed.
2.5

ACS 753 handling

The ACS 753 must normally be moved on flat surfaces
with a maximum slope of 15° and on four wheels,
avoiding excessive shaking. When stopped the front
wheels brake must be engaged. On slightly irregular
surfaces, the ACS 753 can be moved, keeping it
slightly inclined and set on the ground on the two rear
wheels making sure to have a firm grip on the rear
handle.
CAUTION: Although the heavier components
of the ACS 753 are installed on the
bottom of the ACS 753 in order to lower
the center of gravity as much as possible,
the risk of overturning is not completely
eliminated.
en
|
SP00D00596 2019-07-04