Application Limitations; Maintenance; Safety Directions; Maintenance Table - REHM BOOSTER.PRO 170 Instructions De Service

7

Application limitations

The units can be used in any environmental conditions corresponding to
Protection Class IP23 or lower. For welding in certain locations (e.g.
stables), the Protection Class of the welding units has to meet special
requirements. The possibility of using the units in such an environment
should be examined for each individual case. The units are not intended
to be used for more than one shift per day.
8

Maintenance

8.1

Safety directions

Repair and maintenance may only be carried out by persons who
have received appropriate training from REHM. Please contact your
REHM dealer. When replacing parts, use only original REHM spare
parts.
If maintenance or repairs are undertaken by persons who have not
been trained by REHM and are not authorised for this work, then
REHM will not accept any liability or warranty claims.
The welding unit must be switched off and disconnected from the
mains supply before cleaning commences!
Before maintenance is carried out, the welding unit must be
switched off and disconnected from the mains supply and
protected against being switched back on inadvertently.
Supply hoses must be blocked off and depressurised.
The warnings contained in  Chap.2 "Safety Instructions" must be
observed.
The welding equipment and its components must be maintained in
accordance with the specifications in the operating and maintenance
instructions.
Inadequate or inappropriate maintenance or repair work can lead to
technical faults during operation. Regular maintenance of the equipment
is therefore essential. No structural modifications or additions to the
equipment may be undertaken.
8.2

Maintenance table

The maintenance intervals are recommended by REHM for normal
standard requirements (e.g. one-shift operation, use in clean, dry
surroundings). The precise intervals will be determined by your safety
officer.
GB
16