Installation/Connection
Connect external components
No
Part
1
Microphone input jack (Page 15)
2
Output terminals (See the following "Connect external amplifiers via output terminals".)
Connect external amplifiers via output terminals
When connecting an external amplifier to the output terminals of this unit,
securely connect the amplifier ground wire to the car chassis to prevent
damage to the unit.
Model
Output terminals
REAR:
/
FRONT:
SW:
REAR/SW: Rear/subwoofer output
32
ENGLISH
2-way crossover
3-way crossover
Rear output
Tweeter output
Front output
Mid Range output
Subwoofer output
Woofer output
Woofer output
References
Maintenance
Cleaning the unit
Wipe off dirt on the faceplate with a dry silicone or soft cloth.
Cleaning the connector
Detach the faceplate and clean the connector gently
with a cotton swab. Be careful not to damage the
connector.
More information
For: – Latest firmware updates and latest compatible item list
– KENWOOD original application
– Any other latest information
Visit <www.kenwood.com/cs/ce/>.
Playable files
• For USB mass storage class device:
MP3 (.mp3), WMA (.wma), AAC (.aac), AAC (.m4a), WAV (.wav), FLAC (.flac)
• Playable USB device file system: FAT12, FAT16, FAT32
Even when audio files comply with the standards listed above, playback may be impossible
depending on the types or conditions of media or devices.
• For detailed information and notes about the playable audio files,
visit <www.kenwood.com/cs/ce/audiofile/>.
About USB devices
• You cannot connect a USB device via a USB hub.
• Connecting a cable whose total length is longer than 5 m may result in abnormal playback.
• This unit cannot recognize a USB device whose rating is other than 5 V and exceeds 1.5 A.
Connector (on the reverse
side of the faceplate)