References; More Information - Kenwood KDC-BT960DAB Mode D'emploi

Installation/Connection
7 Remove the film covering the earth sheet and paste the earth sheet on the metal part
of the vehicle.
Provide sufficient leeway for the earth sheet so that it does not interfere with the interior parts
(front pillar cover). Also take care that the interior parts do not interfere with the amplifier unit
(G).
Windscreen
(G)
Front pillar cover
8 Wire the antenna cables.
Use cable clamper (H) to secure the antenna to the pillar at several positions.
9 Attach the front pillar cover back to its original position.
Be sure not to damage the earth sheet and amplifier unit (G) when covering.
10 Connect the amplifier unit (G) to the DAB antenna jack on the rear of the unit.
Note:
Make sure [DAB ANT POWER] is set to [ON] on the [FUNCTION] menu in standby
mode. (Page 5)
[ON] is selected initially.
36
ENGLISH
Earth sheet

References

Maintenance
Cleaning the unit
Wipe off dirt on the faceplate with a dry silicone or soft cloth.
Cleaning the connector
Detach the faceplate and clean the connector gently
with a cotton swab. Be careful not to damage the
connector.
Handling discs
• Do not touch the recording surface of the disc.
• Do not stick tape etc. on the disc, or use a disc with tape stuck on it.
• Do not use any accessories for the disc.
• Clean from the center of the disc and move outward.
• Clean the disc with a dry silicone or soft cloth. Do not use any solvents.
• When removing a disc from this unit, pull it out horizontally.
• Remove burrs from the center hole and disc edge before inserting a disc.

More information

For: – Latest firmware updates and latest compatible item list
– KENWOOD original application
– Any other latest information
Visit <https://www.kenwood.com/cs/ce/>.
General
• This unit can only play the following CDs:
• For detailed information and notes about the playable audio files, visit
<https://www.kenwood.com/cs/ce/audiofile/>.
Connector (on the reverse
side of the faceplate)