Using Infrared Receivers In Different Rooms - Marmitek MEGAVIDEO55 Mode D'emploi

3. Position the red plastic part containing the infrared receiver where it can be seen
from where you want to use your remote control. Avoid direct sunlight or light
from a plasma screen.
4. Connect one of the two supplied transformers to the metal part of the IR receiver.
5. Turn the switch on the side of the red plastic part to the ON position.
6. Connect the supplied IR extender cable to the side of the modulator, where it is
marked 'IR OUT'. The IR LED has a self-adhesive backing. Remove the protective
sheet and stick the IR LED carefully over the IR sensor on your video recorder, DVD
player or satellite receiver. This IR sensor can usually be recognised by the dark
coloured plastic window.
7. Point your own remote control at the infrared receiver and press a button, for
instance one used to change the channel or select a different function. If all is well
the attached appliance will now react. If not, then move the IR LED and try again.
The location in which the IR LED responds can sometimes be very small. As soon as
the function works correctly you can firmly attach the eye to the appliance. This will
not damage your appliance.

7. USING INFRARED RECEIVERS IN DIFFERENT ROOMS

If you want to operate your appliance from a number of TVs you can purchase extra infrared
receivers (art. no. 09586).
NOTE: If you have more than one receiver ensure that only one of these receivers is switched
on at any time (one receiver switched 'ON' and the other receivers switched 'OFF'). If you fail
to do this your infrared commands will not be transmitted correctly.
8
INFRARED RECEIVER
INFRARED RECEIVER
© MARMITEK