Setting The Infrared Return Channel For Using Remote Control - Marmitek MEGAVIDEO55 Mode D'emploi

NOTE:
• The leftmost 7 switches (1 to 7 incl.) are for setting the channel.
• The 8th switch is used to turn the test picture on or off (up is on). That is why this switch is
normally shown in the 0 position in the attached list.
• Use the 9th switch to choose between a high (ON setting = 82dBµV) and a low (OFF setting =
72dBµV) output power. If you see interference (white noise) on the screen of the MegaVideo55,
please set this switch to a different setting. NB: if the output power is too high, this can also
cause interference!
4. After you have set the channel you can turn on a test pattern using the 8th dip switch. To do
this set the dip switch to ON (= 1). This pattern consists of a number of black and white bars
on the screen.
5. Turn on the TV and find the channel that you have set. Your TV's operating instructions will tell
you how to do this. You will now see the test pattern on the set channel. Now check that there
is no interference on the neighbouring TV channels. If there is, you should select another two
(or if possible) three free channels and set the modulator to these channels.
After you have done this set the 8th dip switch (test pattern) back to OFF. From now on you will be
able to watch the attached A/V appliance on the channel that you have set.
6. Now turn on the required A/V appliance (DVD, video recorder, satellite receiver, PC, camera,
etc.). You can now view the signal on the TV. If you have a number of TVs connected to the
same aerial network then you can also view this signal on the other TVs. To do so you will first
have to set the correct channel on each TV.
.
6. SETTING THE INFRARED RETURN CHANNEL FOR
USING REMOTE CONTROL
An infrared receiver is supplied with the set. This receiver can be fitted between the TV
and the aerial signal. The receiver converts the infrared signal from your remote control
and sends this signal back to the modulator through the aerial cable. Works with
almost all brands and models of remote controls (except B&O).
Using the supplied infrared eye you can convert this back to an infrared signal and send
it to the connected appliance. In this way you can operate the connected appliance
(e.g. a DVD player) from another room. It is easier to connect this if someone helps
you.
1. Disconnect the aerial cable connected to the back of your TV. Connect this to the
'ANT IN' / 'In' connection on the metal part of your infrared receiver.
2. Reconnect the 'TV OUT' / 'To TV' side to your TV. You can use the supplied
adaptors for this (F connector to IEC).
MEGAVIDEO 55
TM
7