Technical Specifications; Product Maintenance - Fracarro KSP1_2 Série Notice D'installation

Masquer les pouces

Table Des Matières

Table des Matières

Les langues disponibles

Optical wavelength (nm)*

Number of optical outputs

Typical optical insertion loss (dB)

Maximum optical insertion loss (dB)

Isolation (dB)

Typical Optical Reflection (dB)

Optical Connector

Dimensions (l x h x d) mm

Working temperature (°C)

The technical data are nominal values and refer to an operating temperature of 25° C.

* TESTED ONLY 1310 nm

WARNING : unplug the laser source before cleaning the optical splitter connectors.

Optical connectors are similar to glasses lenses and, therefore, their performance is decreased by dust, particles, finger

grease and scratches.

To clean the SC-APC optical connector:

1. Open the connections.

2. Apply a drop of cleansing liquid (pure alcohol) on the end surface and remove possible remaining particles

with compressed air.

3. Before connecting the connectors again, clean by applying a drop of cleansing liquid (pure alcohol) in the

central hole and dry with compressed air.

4. Reconnect the connectors in the adapter while avoiding any contact with the ends or any other surface

and your fingers.

Notes :

•

connectors/adapter must always be protected by their covers.

•

Never open the connections in humid or dusty rooms

•

use only pure alcohol for cleaning operations.

•

scratched connectors can damage other connectors; therefore, they must be replaced.