5.1.1 Setting the child lock
To activate the setting mode:
u Press the Fast Cool button
w The Menu symbol is shown on the display,
flashes on the display.
w
c
To switch on the function:
u Briefly confirm using the Fast Cool button
Fig. 2 (4) .
appears on the display.
w
c1
u Briefly confirm using the Fast Cool button
Fig. 2 (4) .
Fig. 2 (8) , lights up on the
w The child lock symbol,
display.
flashes on the display.
w
c
w The child lock function is switched on.
If the function is to be switched off:
u Briefly confirm using the Fast Cool button
Fig. 2 (4) .
appears on the display.
w
c0
u Briefly confirm using the Fast Cool button
Fig. 2 (4) .
flashes in the display.
w
c
w The child lock function is switched off.
To end the setting mode:
u Briefly press the On/Off button
w The temperature display shows the temperature again.
5.2 Door alarm
An audible warning sounds if the door is open for
longer than 60 seconds.
The audible warning stops automatically when the
door is closed.
5.2.1 Muting the door alarm
The audible alarm can be muted when the door is open. The
sound switch-off function is active as long as the door is left
open.
Fig. 2 (6) .
u Press alarm button
w The door alarm is silenced.
5.3 Refrigerator compartment
The natural circulation of air in the refrigerator compartment
results in zones differing in temperature. It is coldest directly
above the plate separating off the ClimatFreshbox zone and at
the rear wall. It is warmest at the top front of the compartment
and in the door.
5.3.1 Food refrigeration
Note
The energy consumption increases and the cooling perform-
ance decreases if the ventilation is inadequate.
u Always keep the air slits of the fan free.
u Place butter and preserves in the upper area and in the door
(see Appliance at a glance).
u Use recyclable plastic, metal, aluminium and glass
containers and cling film for wrapping.
u Always store liquids and food which is subject to odour or
taste transfer in closed containers or cover them.
u Foods which give off a large amount of ethylene gas and
delicate foods, such as fruit, vegetables, salad, should
always be stored separately or wrapped so as not to reduce
the storage life; e.g. do not store tomatoes together with
kiwis or cabbage.
* Depending on model and options
Fig. 2 (4) for approx. 5 seconds.
Fig. 2 (7) .
Fig. 2 (1) .
u Use the front area of the refrigerator compartment floor only
for briefly putting down cooled products, e.g. when rear-
ranging and sorting. However do not leave cooled products
there otherwise they may be pushed back or tipped over
when the door is closed.
u Do not store food too close together to enable good air
circulation.
5.3.2 Setting the temperature
The temperature depends on the following factors:
-
the frequency of opening the door
-
the room temperature of the installation location
-
the type, temperature and quantity of the food
Recommended temperature setting: 5 °C
An average temperature of approx. -18 °C is then established
in the freezer compartment.*
The temperature can be adjusted continually. Once the setting
3 °C is reached, the cycle is begun again at 9 °C.
u Call up the temperature function: Press the "+/-"
Fig. 2 (3) .
setting button
w The previously-set value will flash in the tempera-
ture display.
u Change the temperature in 1 °C steps: Press the
Fig. 2 (3) until the required
"+/-" setting button
temperature is indicated in the temperature
display.
u Change temperature continually: hold down
setting button.
w During adjustment the value flashes on the display.
w The new setting is adopted approx. 5 seconds after the last
time the button was pressed and the set temperature is
again displayed. The temperature in the interior gradually
adjusts to the new value.
5.3.3 Fast Cool
Use Fast Cool to activate the highest cooling
performance to reach lower cooling temperatures.
Fast Cool is used for rapidly cooling large amounts of
food.
Fast Cool has a slightly higher energy consumption
To cool using Fast Cool
u Briefly press the Fast Cool button
Fig. 2 (5) illuminates in the display.
w The Fast Cool symbol
w The cooling temperature drops to the coldest value.
Fast Cool is switched on.
w Fast Cool automatically switches itself off after approx. 12 h.
The appliance continues to function in the energy-saving
normal mode.
To switch off Fast Cool ahead of time
u Briefly press the Fast Cool button
Fig. 2 (5) goes out in the display.
w The Fast Cool symbol
w Fast Cool is switched off.
5.3.4 Shelves
Moving or removing shelves
The shelves have stops preventing them from being uninten-
tionally pulled out.
Control
Fig. 2 (4) .
Fig. 2 (4) .
23