KIKKA BOO STARS Mode D'emploi page 5

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
FIG. 4 - INSTRUCTION
1. Put the baby into the seat pad, lock the ve-point safety button according to below pictures, and then cover the seat
pad bag. The length of the safety belt can be adjusted by shoulder and waist button.
2.Fix the shoulder tape according to below the pictures. : 2.1 - top -bottom ; 2.2-The tape is out from top ; 2.3-Overturn
from bottom 2.4- Fasten the tape
3.Control panel introduction: 3.1- Volume/ Music switch: press one time to start the music, and the second time to
stop the music. (With 12 pcs music). Continue to press this button can adjust the volume bigger or lower circularly. 3.2:
Electronic toys button, when press it, toys will be rotated. Press second time, then stop rotating and 7 colors light will be on.
Press third time, toys will be rotated and lights will be on. And fourth time all functions are closed. 3.3 Power switch button,
when in ON place,it' s toys power on, when pull on OFF place, it' s power OFF
4.
4 pcs "AAA" batteries are needed for this product. -As below picture shown, use the screwdriver to take out the screws, remove the
battery cover, put the batteries to the battery container according to the correct polarity. The same way to take the batteries out
from the battery container.
4.1. Put the 7# battery negative end into the battery box with spring end. ; 4.2. Naje syre all batteries are at ; 4.3.
Close and xed battery cover
5. There are two positions of seat: as following pictures shown, press both side of buttons to adjust lying position and sitting
position as below picture shown.
5.1. Press the adjusted button of twosides of seat rotate the arrow direction -LIE POSITIONS
5.2. Sit position
6. Vibration box function: there are 3 positions on vibration box, from left (power switch) to right can increase vibration speed.
When in most left place, it' s power o . As below picture shown.
7. 1pc "D" battery is needed for this procust. As below picture shown, use the screwdriver to take out the screws, remove the
battery cover, put the batteries to the battery jar according to the correct polarity. The same way to take the batteries out from the
battery jar.
7.1 Put the 1# battery follow positive and negative end diraction , then put the battery convex part (positive and)
into battery box with positive end. Make sure all batteries are at.
7.2 Close and xed battery cover.
Non-rechargeable batteries can't be recharged.
Rechargeable battery can only be charged under adult supervision.
Rechargeable battery should be taken out of the swing before charging.
Di erent types of batteries or old and new batteries can not be mixed.
The batteries should be placed in the correct polarity.
Remove the exhausted batteries from the toys. Do not allow baby to play alone.
Power supply terminal must not short-circuit.
CLEARNESS AND MAINTENANCE
1.Seat pad is lled with hard rosin cotton and is removable; installed in the swing frame; scrub with clean cold water.
WARNING!
orbid to machine wash, bleach and dehydrate.
F
2.Common maintenance:
-The music and vibration stop suddenly - The batteries are not xed well or the power is not enough.
-No functions when starting the work - Check whether the batteries are installed incorrectly.
-When press buttons , hear the WARNING!! Sound - It my be not power on batteries. Changed new ones
-Not work on vibration box - It may the batteries not put well or lower power on batteries.
ENGLISH

Publicité

Table des Matières
loading

Table des Matières