WMF KULT pro Mode D'emploi page 11

You can set the speed of the high-performance motor to 12 levels between a min
and max by using the selector switch on the propulsion unit. To start, select the
desired level. Then press the start button and keep it pressed for approximately
3 seconds.
To switch off, either press the stop button or turn the selector switch back to
.
Attention: The mixer will only be switched on if the glass jug is correctly fitted. A
safety shutdown prevents operation without the jug.
ice crush
You can use the ice crush button to easily crush ice cubes. Fill in a maximum of 8
ice cubes and close the glass jug with the lid
and cap. Place the selector switch on the program position. Now press the ice
crush button and the mixer will start an automatic programme with different
speeds and several pauses.
The programme automatically ends after about 30 seconds. You can stop the
programme at any time by pressing the stop button .
smoothie
You can use the smoothie button to easily prepare smoothies. Place the selector
switch on the program position. Now press the smoothie button and the mixer
will start an automatic programme with different speeds.
The programme automatically ends after about 1 minute. You can stop the
programme at any time by pressing the stop button .
interval
You can use the interval button, especially to easily clean the jar. Fill the jug with
a maximum of 1 litre of fresh water and add a few drops of a washing-up liquid.
Place the selector switch on the program position. Now press the interval button
and the mixer will start an automatic programme with different speeds and
several pauses.
The programme automatically ends after about 45 seconds.
You can stop the programme at any time by pressing the stop button .
Afterward, thoroughly rinse the entire jar with fresh water.
Glass Jar
The closing cap in the lid can be removed by rotating it in a clockwise direction
and can be used as a measuring cup (50 ml). The glass jar can be dismantled,
especially for cleaning. To do so, place the jar on the table with the opening
facing down. Rotate the screwed ring counter-clockwise. You can now remove
the blade assembly and the sealing ring.
To assemble, the sealing ring is first attached to the blade assembly. When doing
so, make sure the sealing ring is properly seated on the blade assembly.
Then place the blade assembly in the glass jar. Now place the screwed ring on the
glass jar and rotate in a clockwise direction until it is firmly set.
11