Installing The Unit On A Left-Hand Drive Car - Pioneer Premier DEH-P710BT Manuel D'installation

Installation
Note
• Do not install this unit in such a place as may
obstruct the driver's view.
• Since interior layout differs depending on the type
of vehicle, the ideal installation location for the
unit also differs. When installing the unit, select
a location that assures optimum transmission of
signals from the unit to the car stereo.
Installing the unit on a left-hand
drive car
Note
• When the unit is installed on a right-hand-drive
car, the horizontal positions are inverted.
1. Hook the belt on to the holder.
2. Fix the holder to the inside edge of
the steering wheel so that the holder
is facing the driver.
• 12 Wrap the belt around the outside edge of the
steering wheel, passing the end through the slot
in the holder.
3 Pull on the belt to tighten it then secure it using
the other two hooks on the holder.
1
3. 4 Cut off the extra portion of the belt.
• 5 If some of the belt still protrudes, fold it back
into the slot so that it does not interfere with
driving.
4. Fasten the other belt in the same way.
5. Install the remote control unit in the
holder.
• When removing the remote control unit from
the holder, move the corrugated release section
toward the steering wheel and slide the remote
control unit toward you.