When Installing The Aerial Inside The Vehicle (On The Dashboard Or Rear Shelf) - Pioneer SPH-DA100 Manuel D'installation

Masquer les pouces Voir aussi pour SPH-DA100:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 22
Installation
When installing the aerial inside the vehicle
(on the dashboard or rear shelf)
WARNING
Do not install the GPS aerial over any sensors or vents on the dashboard of the vehicle, as do-
ing so may interfere with the proper functioning of such sensors or vents and may compro-
mise the ability of the double-sided tape under the GPS aerial to properly and securely affix
to the dashboard.
Affix the double-sided tape on the surface as level as possible where the GPS aerial faces the
window. Place the GPS aerial on the double-sided tape.
Notes
When attaching the metal sheet, do not cut
it into small pieces.
Some vehicles use window glass that does
not allow signals from GPS satellites to pass
through. On such models, install the GPS
aerial on the outside of the vehicle.
Metal sheet
GPS aerial
Peel off the protective sheet
on the rear.
Clamps
Use separately sold clamps
to secure the lead where necessary
inside the vehicle.
Make sure the surface is free of
moisture, dust, grime, oil, etc.,
before affixing the metal sheet.
Note
The metal sheet contains
a strong adhesive which
may leave a mark on the
surface if it is removed.
Section
03
19
Engb

Publicité

Table des Matières
loading

Table des Matières