Din Front-Mount; Removing The Unit; Din Rear-Mount - Pioneer Premier DEH-P710BT Manuel D'installation

Installation

DIN Front-mount

Installation with metal strap and
screws
1. Insert the mounting sleeve into the
dashboard.
• When installing in a shallow space, use a
supplied mounting sleeve. If there is enough
space behind the unit, use factory supplied
mounting sleeve.
2. Secure the mounting sleeve by using
a screwdriver to bend the metal tabs
(90°) into place.
3. Install the unit.
Use commercially available parts when
installing.
Screw
Screw
(M4 × 8)
• Make sure that the unit is installed securely in
place. Unstable installation may cause this unit to
malfunction, such as sound skip.
Nut
Filrewall or metal support
Metal strap

Removing the Unit

1. Insert the supplied extraction keys
into both sides of the unit until they
click into place.
2. Pull the unit out of the dashboard.

DIN Rear-mount

1. Determine the appropriate position
where the holes on the bracket and
the side of the unit match.
2. Tighten two screws on each side.
• Use either truss screws (5 mm × 8 mm)
or flush surface screws (5 mm × 9 mm),
depending on the shape of screw holes in the
bracket.
Factory radio mounting bracket
Screw
Dashboard or
Console
1