GEO plast GEOtank Mode D'emploi page 55

Návod na obsluhu / Manual / Mode d´emploi - GEOtank
7. Lifting the screw (worm)
•
Turn off the gear motor and fan (e.g.: heating control – manual operation)
•
Open the attachment screw of the motor unit (2x)
•
Pull out the complete screw unit ca. 20 cm, turn the fan on
•
Suction cleaning ( see section 6 )
•
*** if the screw unit is pulled out completely: disconnect the motor unit from the gear wave
and put it next to the cover unit; pull out the gear wave with the screw afterwards***
•
Turn of fan and plug in screw unit – if the srew unit cannot be inserted into the original
position, turn on the gear motor and fan – the screw ‚eats' itself to the original position (it is
necessary to do the suction cleaning at the same time!)!
•
Attachment screws of the motor unit (2x) re-attach
•
Re-establish the normal mode
V00070130
55