Troubleshooting - Whirlpool GLT3057 Guide D'utilisation Et D'entretien

First try the solutions suggested here. If you need further assistance or more recommendations that may help you avoid a service call,
refer to the warranty page in this manual and scan the code there with your mobile device, or visit producthelp.whirlpool.com.
In Canada, visit www.whirlpool.ca.
Contact us by mail with any questions or concerns at the address below.
In the U.S.A.:
Whirlpool Home Appliances
Customer eXperience Center
553 Benson Road
Benton Harbor, MI 49022-2692
Please include a daytime phone number in your correspondence.
Problem
Nothing will operate
Surface burners will not
operate
Surface burner flames
are uneven, yellow, and/or
noisy
Surface burner makes
popping noises
Excessive heat around
cookware on cooktop
Cooktop cooking results
not what expected

TROUBLESHOOTING

WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Possible Causes and/or Solutions
A household fuse has blown or a circuit breaker has tripped: Replace the fuse or reset
the circuit breaker. If the problem continues, call an electrician.
The power supply cord is unplugged: Plug into a grounded 3 prong outlet.
Cooktop is not properly connected to the gas supply: Contact a service technician or see
Installation Instructions.
First time the surface burners have been used: Turn on any one of the surface burner knobs
to release air from the gas lines.
Control knob set incorrectly: Push in knob before turning to a setting.
Burner ports are clogged: See the "Sealed Surface Burners" section.
The main gas shut-off valve is in the off position: See the Installation Instructions.
Burner ports are clogged: See the "Sealed Surface Burners" section.
Burner caps and heads are positioned improperly: See the "Sealed Surface Burners" section.
Propane gas is being used: The cooktop may have been converted improperly. Contact a service
technician.
The burner is wet: Let it dry.
Cookware is not the proper size: Use cookware about the same size as the surface cooking
area, element, or surface burner. Cookware should not extend more than 1/2" (13 mm) outside the
cooking area.
Proper cookware is not being used: See the "Cookware" section.
Control knob is not set to the proper heat level: See the "Cooktop Controls" section.
Cooktop is not level: Level the cooktop. See the Installation Instructions.
In Canada:
Whirlpool Home Appliances
Customer eXperience Centre
200 - 6750 Century Ave.
Mississauga, Ontario L5N 0B7
11