emerio FH-121976 Mode D'emploi page 6

FH-121976 EN
PARTS DESCRIPTION
1. Control panel
2. Digital display
3. Remote control
4. Air outlet
5. Base
6. Air inlet
7. Indicator light
8. Power switch
Control panel
1. On/off button
2. Power setting button
3. Oscillation button
4. Timer setting button
5. Temperature adjustment button (for increase)
6. Temperature adjustment button (for decrease)
OPERATION
Plug in the appliance into an appropriate electrical outlet. Turn on the appliance by pressing the power switch.
A beep sound will be heard. The appliance is standby with the current room temrature illuminating on the digital
display. Press the on/off button on the control panel to start setting your heater.
1. On/off button
Press the button " " to run your heater in ventilation mode with icon " " illuminating on digital display.
The digital display shows the room temperature. Press the button " " again, the appliance will enter into
standby condition. If the appliance is heating, it will count down 30 seconds before turned into standby mode,
in order to cool the inside off and protect the components. (If you press into the ventilation mode during this
count-down and then press the button " " again, the appliance will resume the count-down unfinished last
time before the appliance goes into standby.)
2. Adjustment button
You can press the button " " or " " to adjust temperature setting. The default is 25℃ and you can set your
desired temperature from 10℃ to 49℃. The set temperature flashes for several seconds and then the display
shows again the room temperature. The heater will automatically stop working when the set temperature is
reached and resume working when the room temperature is lower than the set temperature.
- 5 -