SOMFY animeo IP Manuel D'installation page 9

EN
Before installation, please read and follow these instructions. Incorrect installation may lead to serious injury.
Disconnect all power cables to be installed! Take precautions against unintentional switching on! The product
must be installed, maintained and dismounted by a skilled person according to the relevant regulation. An all-
pole mains switch shall be incorporated in the electrical installation of the building to provide simultaneous
separation of at least 3 mm for all phases from the supply.
Somfy cannot accept any liability for defects and damage caused by failure to follow these instructions. Please
keep these instructions for future reference.
The range of radio controls is restricted by legal requirements for radio installations and structural conditions.
Please pay attention to allowing sufficient radio reception (avoid basement installation!).
The function of controls can be influenced by strong local transmitters (e.g. radio headset) with identical trans-
mitting frequency.
Somfy hereby declares that the radio equipment covered by these instructions is in compliance with the re-
quirements of Radio Directive 2014/53/EU and other essential requirements of the applicable European Direc-
tives. The full text of the EU declaration of conformity is available at www.somfy.com/ce.
Radio frequency
Frequency bands and maximum power used
Somfy limited, Yeadon LS19 7ZA UK, hereby declares that the radio equipment covered by these instructions
is in compliance with the requirements of UK legislation: the Radio Equipment Regulations S.I. 2017 N°1206.
The full text of the UKCA declaration of conformity is available at www. somfy.co.uk
A
MOUNTING
[1] LED
1. Green = voltage
2. Yellow = signal received
3. Green = signal sent
[2] Mount the USB-io Transceiver on a wall
For better radio performance: The transceiver
can be mounted with some distance to the wall
using the 4 enclosed spacers.
[3] Mount it on DIN-rail:
1. Always 90° to the DIN rail
2. Alternating device alignment (for a good radio
performance)
868-870 MHz io-homecontrol®, two-way, tri-band
868.000 MHz – 868.600 MHz e.r.p. <25 mW
868.700 MHz – 869.200 MHz e.r.p. <25 mW
869.700 MHz – 870.000 MHz e.r.p. <25 mW
The animeo IP Building Controller io should not
be installed in the immediate proximity of
metal surfaces.
B
WIRING
[1] Only mount the USB cable downwards with
enough distance to animeo IP Building Controller
or animeo IP Sub Controller.
[2] The USB cable must not be mounted beside or
above the housing or the PCB (Printed Circuit
Board).
Use existing USB cable; do not lengthen it!
animeo IP USB-io Transceiver WM Ref. 5115431D
- 9/24