Beurer BM 51 easyClip Mode D'emploi page 28

Selecting memory
Press the SET setting button. Select the relevant user memory
-
( or ) by pressing the
2
You have 2 memories, each with 100 memory spaces, to
enable the separate storage of measurements for 2 different
people. Confirm your selection with the START/STOP button
or wait for 3 seconds. Your selection is then automatically
stored.
Performing the blood pressure measurement
As described above, attach the cuff and adopt the
posture in which you want to perform the measurement.
• Press the START/STOP button
the blood pressure monitor. All display
values light up briefly. After the full-screen
display, the last stored measurement ap-
pears. If there is no measurement in the
memory, the unit displays the value .
The blood pressure monitor will begin
measurement automatically after 5 seconds.
+
/ function buttons.
to start
The cuff automatically inflates. The measurement itself is
taken during the inflation phase.
As soon as a pulse is found, the pulse symbol
displayed.
You can cancel the measurement at any time by
pressing the START/STOP button
• Systolic pressure, diastolic pressure and
pulse measurements are displayed.
• appears if the measurement has
not been performed properly. Refer to
chapter "10. What if there are problems?"
in these instructions for use and repeat the
measurement.
• Press the START/STOP button
blood pressure monitor. The measurement is then
stored in the selected user memory.
If you forget to turn off the device, it will switch off
automatically after approx. 1 minute. Even in this event,
the value is stored in the selected or most recently used
user memory.
• Wait at least 1 minute before taking
another measurement!
28
will be
.
to switch off the