Tool Requirements; Assembly Instructions - BaSt-ING PumpFast Instructions De Montage Et D'utilisation

4.

Tool requirements

• Oil collecting container including funnel for filling hydraulic oil
• Allen key (4 mm / 6 mm / 10 mm)
• Open-ended spanners 10 mm / 17 mm / 22 mm (2 pieces) / 27 mm
• Socket 17 mm including ratchet
• Hacksaw (O.M.F.B. variant)
• Cordless screwdriver (Chapel plastic tank)
• Socket 32 mm (Chapel plastic tank)
5.

Assembly instructions

Variant: PumpFast Basic
• O pen the lowering throttle of the hand pump to allow possible pressure in the system to escape.
• D rain the hydraulic oil from the tank using the oil drain plug.
• S crew the hydraulic pump into the oil drain screw of the hydraulic tank.
• D ismantle the hydraulic hose from the hand pump head.
• S crew the T-piece into the existing hydraulic line.
• T ighten the loose hydraulic screw connections on the complete system.
• F illing in the hydraulic oil (low-viscosity hydraulic oil is better suited for the PumpFast pump unit
in cold temperatures, e.g. SAE 0W-15).
Notices
• A pply additional anti-corrosion agents to the pump and drive shaft on salty roads.
• A void water deposits on the sealing ring of the drive shaft.
• W hen the system is pumped up for the first time, there may still be air in the system;
this escapes when the system is pumped up several times.
(only suitable for round Chapel steel tank)
– 12 –