Connecting The Battery - MicroPower SMC-HF 3200 Mode D'emploi

Handling
Cable connections and control panel
SMC-HF 3200 (picture 3)
1. Start/Stop button
2. Mains power cable
3. Battery cable
SMC-HF 8000 (picture 4)
1. Pause button
2. Mains power cable
3. Battery cable
Charging
In the event of danger, switch off the mains power by removing the plug from the wall socket.

Connecting the battery

SMC-HF 3200
1. The SMC-HF 3200 battery charger can be continuously connected to the mains
power, indicated by the green Standby light.
2. Check the cabling and connection device to ensure there is no visible damage.
3. Connect the battery to the battery charger.
4. Start the battery charger by setting the Start/Stop button to position 1. The orange LED
will come on. The charging time varies depending on the battery type and the level of
discharge.
5. Once the battery is fully charged, the green LED will come on. The battery charger
will then switch to maintenance charging.
SMC-HF 8000
1. The SMC-HF 8000 battery charger can be continuously connected to the mains
power, indicated by the blue LED being on.
2. Check the cabling and connection device to ensure there is no visible damage.
3. Connect the battery to the battery charger.
4. Battery charger SMC-HF 8000 starts charging automatically once the battery is
connected. The yellow battery symbol will come on. The charging time varies
depending on the battery type and the level of discharge.
5. Once the battery is fully charged, the green battery symbol will come on. The
battery charger will then switch to maintenance charging.
NOTE! If a fully charged battery is connected, it takes some time before the green LED
comes on. This time may vary between 0 to 2 hours.Disconnecting the battery
12
4. LED
5. Standby indicator
6. Program switch (hidden under plastic plug)
4. LED/Symbols
5. Standby indicator
WARNING