Remote Control Handset; Inserting Batteries; Switching On/Off; Input Selection - Grandin LC16M211 Mode D'emploi

Scart Cable
(not supplied)
External device
Note: These three methods of connection perform the
same function but in different levels of quality. It is not
necessary to connect by all three methods.

Remote Control Handset

Inserting Batteries

• Remove the battery cover located on the back of
the handset by gently pulling backwards from the
indicated part.
• Insert two AAA/R3 or equivalent type batteries
inside. Observe the correct polarity (+/-) when
inserting batteries and replace the battery cover.
Note: Remove the battery from remote control
handset when it is not to be used for a long period.
Otherwise it can be damaged due to any leakage of
batteries. Remote range is approximately 7m/23ft.
01_woypbpr_[GB]_MB60_1900UK_PVR_BRONZE17_16911WLED_10072246_50184497.indd 11 01_woypbpr_[GB]_MB60_1900UK_PVR_BRONZE17_16911WLED_10072246_50184497.indd 11

Switching On/Off

To Switch the TV On
• Connect the power cord to the 220-240V AC, 50
Hz. Then the standby LED lights up. (The led will
blink during the standby On/Off)
• To switch on the TV from standby mode either:
• Press the " " button, P+ / P- or a numeric button
on the remote control.
• Press the " " button, - or + button on the TV. The
TV will then switch on.
Note: If you switch on your TV via PROGRAMME
UP/DOWN buttons on the remote control or on the
TV set, the programme that you were watching last
will be reselected.
By either method the TV will switch on.
To Switch the TV Off
• Press the " " button on the remote control or press
the " " switch on the TV, so the TV will switch to
standby mode.
• To power down the TV completely, unplug the
power cord from the mains socket.
Note: When the TV is switched to standby mode,
standby LED can blink to indicate that features such
as Standby Search, Over Air Download or Timer is
active.

Input Selection

Once you have connected external systems to
your TV, you can switch to different input sources.
Press "SOURCE" button on your remote control
consecutively for directly changing sources.
Note: YPbPr mode can be used only when you
connect a device that has a YPbPr output through the
PC input with YPbPr to PC cable (not supplied).
English - 11 -
08.02.2011 11:37:20 08.02.2011 11:37:20