Transmitter Range Chart; Record Your Settings - Petsafe Stay & Play PIF19-17106 Manuel D'utilisation

Table des Matières

Les langues disponibles

Two-Person Method

Hold the receiver collar around waist height with logo side facing away from the transmitter and contact points facing upwards. Walk to the

edge of the desired pet area. Facing away from the transmitter, hold the receiver collar at the edge of the desired pet area (4C).

Starting with the boundary control dial set to "8", have a second person turn the dial down SLOWLY. When the receiver collar tone starts, tell

the person to stop turning the boundary control dial. Walk back into the pet area until the receiver stops sounding. Verify the pet area boundary

by walking towards the boundary zone and verifying that the tone/test light flashes begin at the desired location. Test at multiple locations

around the pet area to verify that the pet area is within your desired location. Record your settings below for future reference.

One-Person Method

Measure the shortest distance from the desired boundary zone to the transmitter. See the transmitter range chart below and set the boundary

switch and boundary control dial. Hold the test light contacts to the contact points (4B). Take the receiver collar to the boundary zone with

the logo side facing away from the transmitter and contact points facing upwards (4C). Hold the receiver collar around waist height until the

receiver collar tone sounds and the test light flashes. If the receiver collar tone sounds before or after the desired boundary zone, return to the

transmitter and adjust the boundary control dial. Repeat this process until the receiver collar tone sounds at the desired location. Record your

settings below for future reference.