Milwaukee 5192 Manuel De L'utilisateur page 5

Your tool must be plugged into an appro-
priate outlet, properly installed and
grounded in accordance with all codes
and ordinances. The plug and outlet
should look like those in Figure A.
Double Insulated Tools (Two-Prong Plugs)
Tools marked "Double Insulated" do not require
grounding. They have a special double insulation
system which satisfies OSHA requirements and
complies with the applicable standards
of Underwriters Laboratories, Inc., the
Canadian Standard Association and
the National Electrical Code. Double
Insulated tools may be used in either
of the 120 volt outlets shown in Figures
B and C.
SPECIFICATIONS
Volts .......................................................120 AC/DC
Max Wheel Ø ....................................................... 2"
Cat. No. .................................................5192, 5194
Amps ..................................................................4.5
Rated RPM ...................................................23,000
Cat. No. ...........................................................5196
Amps ...................................................................11
Rated RPM ...................................................16,000
FUNCTIONAL DESCRIPTION
Cat. No. 5192
1
4
2
5
Cat. No. 5196
7
Cat. No. 5194
Fig. A
Fig. B Fig. C
1. Cord
2. Handle
2
3. Collet nut
4. Toggle switch
5. Trigger switch
6. Collet flange
7. Paddle switch
6
3
WARNING
removing accessories. Only use accessories
specifically recommended for this tool. Others
may be hazardous.
Care of Mounted Points, Grinding Wheels
Points, grinding wheels and cut-off wheels should
be protected from:
• wetness and extreme humidity
• any type of solvent
• extreme changes in temperature
• dropping and bumping
Points, grinding wheels and cut-off wheels should
be stored:
• in an organized way so points or wheels can be
removed without disturbing or damaging other points
or wheels
• with their safety information
Points, grinding wheels and cut-off wheels should
NOT be dropped, rolled or bumped.
Discard points or wheels that have been dropped,
rolled, bumped, subjected to extreme changes in tem-
perature, or come into contact with solvents or wetness.
MILWAUKEE Die Grinders feature a special collet
and collet nut. The collet must be attached to the
collet nut before installing the collet asembly to the
tool. Be sure that the collet size matches the size of
the mounted wheel mandrel you will use, otherwise
the collet may break.
1. To assemble, place collet on an even surface, take
nut and place over collet.
3
2. Position nut squarely over collet.
3. Snap nut and collet together by firmly applying
downward pressure onto assembly with the palm
of hand.
4. To disassemble collet from nut, hold nut firmly with
one hand and press the collet to one side with the
other hand.
5
ASSEMBLY
To reduce the risk of injury, always
unplug tool before changing or
& Cut-Off Wheels
Installing Collets